Accessories - DeWalt DCLE34220 Instructions Manual

SHOULD NOT BE USED FOR DETERMINING OR
MARKING LEVEL OR PLUMB. Try repositioning the
laser on a more level surface.
The Laser Beams Will Not Stop Moving
The laser is a precision instrument. Therefore, if it is
not positioned on a stable (and motionless) surface,
the laser will continue to try to find level. If the beam
will not stop moving, try placing the laser on a more
stable surface. Also, try to make sure that the surface is
relatively flat, so that the laser is stable.
The Battery Meter LEDs Flash
When all 4 LEDs continuously flash on the Battery
Meter this indicates that the unit has not been fully
powered off using the Power/Transport Lock switch
). The Power/Transport Lock switch
(Figure
C 2
should always be placed in the LOCKED/OFF position
when the laser is not in use.

Accessories

The laser is equipped with both 1/4 - 20 and 5/8 - 11
female threads on the bottom of the unit
(Figure ). This thread is to accommodate current
M
or future D WALT accessories. Only use D
e
accessories specified for use with this product. Follow
the directions included with the accessory.
WARNING:
Since accessories, other than those
offered by D WALT, have not been tested
e
with this product, use of such accessories
with this tool could be hazardous. To reduce
the risk of injury, only D
accessories should be used with this product.
If you need any assistance in locating any accessory,
please contact your nearest D
go to www.D WALT.com.
e
WALT
e
WALT recommended
e
WALT service center or
e
Target Card
Some laser kits include a Laser Target Card (Figure
to aid in locating and marking the laser beam. The
target card enhances the visibility of the laser beam as
the beam crosses over the card. The card is marked
with standard and metric scales. The laser beam
passes through the red plastic and reflects off of the
reflective tape on the reverse side. The magnet at the
top of the card is designed to hold the target card to
ceiling track or steel studs to determine plumb and level
positions. For best performance when using the Target
Card, the D WALT logo should be facing you.
e
Laser Enhancement Glasses
Some laser kits include Laser En hancement Glasses
(Figure ). These glasses improve the visibility of
P
the laser beam under bright light conditions or over
long distances when the laser is used for interior
applications. These glasses are not required to operate
the laser.
CAUTION:
These glasses are not ANSI approved
safety glasses and should not be used while
operating other tools. These glasses do not
keep the laser beam from entering your eyes.
CAUTION:
To reduce the risk of serious injury,
never stare directly into the laser beam with or
without these glasses.
Ceiling Mount
The laser ceiling mount (Figure
more mounting options for the laser. The ceiling mount
has a clamp (Figure ) at one end which can be fixed
N 2
to a wall angle for acoustic ceiling installation
(Figure ). At each end of the ceiling mount is a
N 3
screw hole (Figure and
N 4
mount to be attached to any surface with a nail or screw.
)
O
), if included, offers
N 1
), allowing the ceiling
N 5
23
E