Mazda MAZDASPEED 6 2007 Quick Tips page 7

Seats
S E A T S
Shoulder belt height
adjustment
To raise: Push
adjuster upward
1
To lower: Pull
button (1) and
slide downward
WARNING: Make sure adjuster
locks in one of its positions
Manual controls
1. Fore-aft adjustment
Lift lever and hold, slide
seat, release lever
2. Raise/lower seat
Pull/push lever repeatedly to
desired height and release
3. Seatback angle
To adjust: Lift and hold lever, lean
forward or backward, release lever
4. Head restraint
To raise/lower: Pull up/push in
release button (8) and push down
WARNINGS: Even with a
deactivation system, never
place rear-facing infant-safety
seat in front of any air bag,
an infant is in serious danger
of being injured or killed
If you must install a forward-
facing child-safety seat in the
front seating position, move
vehicle seat as far back as possible
Use age appropriate child
restraints, see Owner's Manual
and state or province laws
Passenger air bag
deactivation indicator light
Front air bag deactivation indicator
light provides current status of
front passenger air bag and
pretensioner system
If total seated weight on front
passenger seat is less than approxi-
mately 66 lb., front passenger air
bag deactivation indicator light
illuminates, front and side air bags/
Always check the Owner's Manual for more operating information and safety features
Safety
WARNINGS: Do not adjust
seats while driving
Seat belts must always be
worn when vehicle is in motion
Air bags are supplemental
and do not replace seat
belt usage
Always wear your
seat belt and properly
secure children 12
and under in
the rear seat
3
6
2
1
pretensioner will not deploy/activate
in an accident
If the total seated weight is greater
than approximately 93 lb., light
does not illuminate, and the front
and side air bags/pretensioner will
deploy/activate in an appropriate
accident, see Owner's Manual
for additional information on this
feature and the air bag system
Child-safety seat
See Owner's Manual for proper
installation and child seat tether
and LATCH system instructions
Automatic locking mode
(front passenger and all
rear seat belts only)
Must be used when installing
child-safety seat
To activate: Pull webbing fully out of
retractor, allow belt to retract until
click is heard; belt will only tighten
To disengage: Unbuckle belt and
allow webbing to retract fully
5. Lumbar adjustment
Pull lever (5) repeatedly up to 3
times for greater lumbar support
Power driver's seat*
6. Raise/lower front of
seat cushion
Pull/push front of switch vertically
Fore/aft adjustment
Slide switch horizontally
Raise/lower rear of
4
seat cushion
Pull/push rear of switch vertically
8
Raise/lower seat
Pull/push center of switch
vertically
7. Seatback angle
Press front/rear of switch
5
Tip: Verify side air bags by
locating "SRS AIRBAG" indicator
7
tags on outboard side of
front seatbacks
*Denotes optional equipment
Seat belt emergency
locking mode
Belts lock only on hard acceleration,
braking, cornering or impacts of
about 5 mph or more
Child-safety locks
Located at the
Lock
edge of rear doors
To activate: Pull tab
Unlock
up to lock door;
door opens from outside only
To cancel: Push tab down
WARNING: Since children
may access either rear door,
child-safety locks for both rear
doors should be activated
Trunk internal
safety release
Located on interior
trunk lid; slide
illuminated release lever in
direction of arrow; lever glows
if exposed to light