Mazda MAZDASPEED 6 2007 Quick Tips page 4

G E T T I N G S T A R T E D
MAZDASPEED6
Turbocharger tips
To get maximum performance
from your turbocharged engine,
take note of the following:
Use 91-93 octane premium
unleaded gasoline ONLY, extra fuel
additives are NOT recommended
Change engine oil and filter
every 7,500 miles, or sooner if
needed, see Owner's Manual
Use engine oil with API SL or
ILSAC GF-3 service grade
or higher, extra oil additives
are NOT recommended
Remote window operation
Windows can be opened/closed
from outside vehicle when doors
and trunk are closed
Opening windows with Remote
keyless entry: Press unlock button
(2) and hold it, doors and trunk
unlock and windows fully open
Key/Auxiliary key: Insert key
in driver's door lock; turn
toward front/rear of vehicle
and hold it, after doors and
trunk are unlocked/locked
windows will open/close
Closing windows (Advanced key):
with doors and trunk unlocked;
press and hold request switch
on driver's door handle, doors
and trunk will lock, then
windows will fully close
Always check the Owner's Manual for more operating information and safety features
After driving at freeway speeds
or up a long hill, idle engine at
least 30 seconds to cool turbo,
avoid shutting engine off
abruptly after a hard or long
drive, turbocharger damage
may result otherwise
Do NOT race or over-rev ANY
engine when starting, particularly
a turbocharged engine
Do NOT add aftermarket
devices to alter the engine's
ignition, fuel delivery, or turbo
boost pressure, this may lead
to serious engine damage
and void your warranty
4
5
4-Window auto open/close
with anti-pinch function
One-touch open/close: Push down/
pull up AUTO switches (4) firmly
and release, window opens/closes
all the way; pull/push back briefly
to stop window; press/pull lightly
and hold for normal operation
Tip: During closing window
operation, window will stop and
open partway if object blocks
window operation
Power window lockout switch
Press button (5), only driver's
window operates; press again
for normal operation
Getting
Started
Getting
Started
Remote
keyless
entry
1
system
2
Functions only
3
with ignition in
OFF position
To lock doors: Press button
(1); pressing again within a few
seconds causes doors to relock
and horn to beep
To unlock: Press button (2) for
driver's door; press again within 3
seconds to unlock passenger's
door and trunk
Panic alarm: Press and hold
button (3) for more than 1 second;
horn sounds, hazard warning
lights flash; to stop, press
any remote button
Power window
initialization procedure
If battery is disconnected or power
window fuse is replaced, the auto
open/close and anti-pinch features
will not function
Resetting procedure:
1. Turn ignition switch to "ON"
position
2. From driver's seat, ensure
power window lockout switch
(5) is NOT depressed
3. Press power window switch
down to fully open window,
then pull switch up to close
window completely, continue
holding switch up for at least
3 seconds, then release switch
4. Repeat Step 3 for each front
and rear window
5. After all windows have been
initialized turn ignition to
"LOCK", then back to "ON"