Care And Cleaning; Troubleshooting - HAMPTON BAY HB-5610-WH Use And Care Manual

Care and Cleaning

□
To prolong the original appearance, clean with clear water and a soft, damp cloth only.
□
Do not use paints, solvents, or other chemicals on this light fixture. They could cause a premature
deterioration of the finish. This is not a defect in the finish and will not be covered by the warranty.
□
Do not spray with a hose or power washer.

Troubleshooting

Problem
The light will not come on.
The light comes on during the
day.
The light comes on for no
apparent reason.
Possible Cause
□
The light switch is turned off.
□
The bulb is loose or burned out.
□
The fuse is blown or the circuit breaker
is turned off.
□
Daylight turn-off (photocell) is in effect.
□
The circuit wiring is incorrect, if this is
a new installation.
□
The motion sensor is aimed in the
wrong direction.
□
The outside air temperature is close to
the same as a person's body heat.
□
The motion sensor may be installed in a
relatively dark location.
□
The "ON-TIME" switch is in the "TEST"
position.
□
The motion sensor may be sensing
small animals or automobile traffic.
□
The "SENS" switch is set too high.
□
The outside temperature is much
warmer or cooler than a person's body
heat (summer or winter).
□
The light fixture is wired through a
dimmer or timer.
9
Please contact 1-855-HD-HAMPTON for further assistance.
Solution
□
Turn the light switch on.
□
Check the bulb and replace
if burned out.
□
Replace the fuse or turn the
circuit breaker on.
□
Recheck after dark.
□
Verify the wiring is correct.
□
Re-aim the motion sensor
to cover the desired area.
□
Increase the "SENS" set-
ting.
□
The light fixture is operat-
ing normally under these
circumstances.
□
Set the "ON-TIME" switch
to the 1, 5, or 10 minute
setting.
□
Re-aim the motion sensor.
□
Decrease the "SENS"
setting.
□
Decrease the "SENS"
setting.
□
Do not use a dimmer or
timer to control the light
fixture. Replace the dimmer
or timer with a standard on/
off wall switch.
HAMPTONBAY.com