NAD M23 Owner's Manual
  1. Manuals
  2. Brands
  3. NAD Manuals
  4. Amplifier
  5. M23
  6. Owner's manual

NAD M23 Owner's Manual

Stereo power amplifier
Hide thumbs Also See for M23:
Table of Contents

Advertisement

Quick Links

M23
®
Stereo Power Amplifier
© NAD M23
Owner's Manual

Advertisement

Table of Contents
loading

Related Manuals for NAD M23

Summary of Contents for NAD M23

  • Page 1 ® Stereo Power Amplifier © NAD M23 Owner’s Manual...

  • Page 2: Important Safety Instructions

    IMPORTANT SAFETY INSTRUCTIONS 14 Outdoor Antenna Grounding - If an outside antenna or cable system SAVE THESE INSTRUCTIONS FOR LATER USE. is connected to the product, be sure the antenna or cable system is FOLLOW ALL WARNINGS AND INSTRUCTIONS MARKED ON THE AUDIO grounded so as to provide some protection against voltage surges EQUIPMENT.
  • Page 3 23 Heat - The product should be situated away from heat sources such as radiators, heat registers, stoves or other products (including amplifiers) CAUTION that produce heat. Changes or modifications to this equipment not expressly approved by NAD Electronics for compliance could void the user’ s authority to operate this WARNING equipment.
  • Page 4 RECORD YOUR MODEL NUMBER (NOW, WHILE YOU CAN SEE IT) The model and serial number of your new M23 are located on the back of the cabinet. For your future convenience, we suggest that you record these numbers here: Model no: .

  • Page 5: Getting Started

    5 Power up the external source ahead of the M23. 6 Set to ON the rear panel POWER switch of M23. The M23 goes to standby mode as shown by the amber status condition of the Power indicator.

  • Page 6: Identification Of Controls

    For the o (Standby) button to activate, two conditions must be c Do not attempt to use M23 if the Power indicator remained illuminated completed. in red despite the checks mentioned above. Bring the M23 to an •...

  • Page 7: Rear Panel

    SELECT SELECT ATTENTION! Ensure that the M23 is unplugged before making any connections. It is also advisable to power-down or unplug all associated components while making or breaking any signal or AC power connections. 1 RIGHT SPEAKERS, LEFT SPEAKERS IMPORTANT NOTES •...

  • Page 8: Bridge Mode

    Only qualified NAD service technicians can have access to this fuse • The Gain Level of the M23 can be set to any of the following - LOW holder. Opening this fuse holder may cause damage thus voiding (29dB), MEDIUM (24dB) and HIGH (19dB).

  • Page 9: Operation

    AUTO STANDBY AUTO SENSE The M23 can be setup to automatically go to standby mode if there is no Auto Sense feature instantaneously turns the M23 to operating mode from active source input within 30 minutes. Auto standby mode can be enabled standby mode if it senses input signal (minimum 20mV RMS input) applied or disabled by the following steps.

  • Page 10: Audio Specifications

    * - Gross dimension includes feet and extended rear panel terminals. NAD SHALL NOT BE HELD LIABLE FOR ANY TECHNICAL OR USER INTERFACE DISCREPANCIES IN THIS MANUAL. THE M23 OWNER’S MANUAL MAY BE SUBJECT TO CHANGE WITHOUT NOTICE. CHECK OUT...
  • Page 12 All rights reserved. NAD and the NAD logo are trademarks of NAD Electronics International, a division of Lenbrook Industries Limited. No part of this publication may be reproduced, stored or transmitted in any form without the written permission of NAD Electronics International.

Table of Contents