NAD M28 Owner's Manual

NAD M28 Owner's Manual

Seven channel power amplifier
Hide thumbs Also See for M28:

Advertisement

M28
®
Seven Channel Power Amplifier
© NAD M28
Owner's Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the M28 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for NAD M28

  • Page 1 ® Seven Channel Power Amplifier © NAD M28 Owner’s Manual...
  • Page 2: Important Safety Instructions

    IMPORTANT SAFETY INSTRUCTIONS • Read instructions - All the safety and operating instructions should be read • Damage Requiring Service - Unplug this product from the wall outlet and refer before the product is operated. servicing to qualified service personnel under the following conditions: •...
  • Page 3 IF IN DOUBT CONSULT A COMPETENT ELECTRICIAN. NAD is a trademark of NAD Electronics International, a division of Lenbrook Industries Limited Copyright 2020, NAD Electronics International, a division of Lenbrook Industries Limited...
  • Page 4: Getting Started

    Power up the external source ahead of the M28. no loose strands of speakers wire. 6 Set to ON the rear panel POWER switch of M28. The M28 goes to FEET INSTALLATION standby mode as shown by the amber status condition of the Power indicator.
  • Page 5: Identification Of Controls

    The rear panel POWER switch must be set to ON position. AUTO STANDBY The M28 can be setup to automatically go to standby mode if there is no active source input within 30 minutes. Auto standby mode can be enabled or disabled by the following steps.
  • Page 6: Rear Panel

    SPEAKER © NAD M28 ATTENTION! Ensure that the M28 is unplugged before making any connections. It is also advisable to power-down or unplug all associated components while making or breaking any signal or AC power connections. 1 BALANCED 2 SINGLE-ENDED •...
  • Page 7 12V trigger output to use this feature. from standby mode. • If you intend not to use the M28 for long periods of time (such as when on vacation), switch off the POWER switch. •...
  • Page 8: Troubleshooting

    POSSIBLE CAUSES POSSIBLE SOLUTIONS No power. • Mains power cord unplugged from mains • Connect the mains power cord to M28’s power source or from M28’s AC mains input. AC mains input and then plug into a mains power source.
  • Page 9: Overall Specification

    17 1/8 x 6 3/16 x 15 inches Shipping weight 21.2 kg (46.7 lbs) * - Gross dimension includes extended rear panel terminals and installed feet Specifications are subject to change without notice. Check out www.NADelectronics.com for updated documentation or latest information about M28.
  • Page 10 All rights reserved. NAD and the NAD logo are trademarks of NAD Electronics International, a division of Lenbrook Industries Limited. No part of this publication may be reproduced, stored or transmitted in any form without the written permission of NAD Electronics International.

Table of Contents