Vector X2 Operation Manual page 15

V
ECTOR
5.6 Display total run time for digital outputs
Deactivated outputs are not displayed!
Procedure

1. Press the ( /
➔ SEL and the actual Date and Time are displayed alternatingly.
2. Press the ( ) or ( ) button until the digital output submenu do and
SEL is displayed.

3. Press the ( /
the ( ) ( ) button.
➔ do, the output number and the value are displayed.

4. Press the ( /
➔ do, the output number and the total runtime of the output are
displayed.
If the runtime is greater than 9999 hours, one bar appears on the
side bar for every 10'000 hours.
The example on the right corresponds to 30345 hours runtime.
Maximum time is 65535 hours = 7.5 years.
5. Press the ( ) or ( ) button to select the next output.
6. Press the ( ) button to finish the inspection.
5.7 Display Software Version
Overview
This section describes how to display the software version of the installed X2 operating system and the firmware version
of the display / operation terminal.
Procedure

1. Press the ( ) and (
➔ BASE and the software version of the X2 system and OP and the
firmware version of the display / operation terminal are displayed
alternatingly.

2. Press the ( ) button to go back to the start menu.
Doc: 70-00-0950A, Serie X2, 20211220
Subjects to alteration
) button longer than 2 seconds.
) button and select the desired output with
) button again

) button simultaneous longer than 2 seconds.
© Vector Controls GmbH, Schweiz
www.vectorcontrols.com
X2-O M
PERATIONS
B D
ANUAL UTTON ISPLAY
Page 15-16