Vector X2 Operation Manual page 13

V
ECTOR

3. Press the ( /
Cooling:
= Cooling only. The controller stays in cooling mode only
and will not switch to heating.
Fan only cooling:
The controller is in fan-only mode. The fan is controlled
=
according to the controller configuration or setpoint. The
cooling output is deactivated.
Heating:
= Heating only. The controller stays in heating mode only
and will not switch to cooling.
Fan only heating:
The controller is in fan only heating mode. The fan is
=
controlled according to the controller configuration or
setpoint. The heating output is deactivated.
Auto operation:
Auto =
Heating and cooling changes automatically as required.
4. Press the ( ) button to finish the setup.
Doc: 70-00-0950A, Serie X2, 20211220
Subjects to alteration
) button and select one of the following functions:
© Vector Controls GmbH, Schweiz
www.vectorcontrols.com
X2-O M
PERATIONS
B D
ANUAL UTTON ISPLAY
Page 13-16