Combined Assembly - Single And Triple Modules - Honeywell TemaLine TemaKey Installation Manual

Modular terminal

Table of Contents

Combined Assembly - Single and Triple Modules

A combined wall assembly of single and triple modules allows you to

create units consisting of 2, 4 and 5 units. This procedure consists

of the following steps:

1. Drill the necessary holes in the wall (2 plastic dowels for each

module), so that the lower plate will cover the hole through which

the cables pass.

2. Insert the cables in the cable clamp without pulling out the screws.

3. Link the frames together by inserting the two enclosed attachment

clips at the rear of the frames (see Figure 6 and Figure 7).

4. Use the dowels to fasten the frame to the wall. Make sure that

the lamellar connector is in the UP position.

5. Adjust the length of the cables so that they protrude by ~10cm

from the wall, and fasten them to the cable crimp.

6. Intertwine the terminators of the cables from the wall and the

extension cable terminators, and fasten them to the cable crimps.

7. Fasten the cable crimp to the contacts in the direction shown in

Figure 6 and Figure 7.

8. Place the remainder of the cable inside the frame and lock the cable

clamp.

Attachment

clip

Figure 6: Combined assembly of two single module wall units

Mounting the Unit on the Wall

NET1

NET2

GND