TP-Link RE210 Quick Installation Manual

Quick
Installation
Guide
AC750 WiFi Range Extender
RE210
Two easy setup options:
1: Using WPS (Wi-Fi Protected Setup)
2: Using a Web Browser
1
Using WPS (Wi-Fi Protected Setup)
Important: In order to use this option, your router must support WPS.
1 Power On
Plug the Range Extender into a wall outlet
close to your router, and wait until the Power
LED is lit and solid green.
3 Relocate
In general, place your WiFi Range Extender about
halfway between your wireless router/AP and
wireless devices.
After moving to a new location, the Extender will
automatically reconnect to your router in
approximately one minute. If possible, try to
place your Range Extender in a location where
the LED is Green.
To minimize wireless interference, place your
Range Extender in an open space area, away from
other bluetooth devices or radioactive devices
such as cordless phone, microwave, etc.
Entertainment Adapter
The Range Extender RE210 can be used as a wireless
adapter to connect any Ethernet-enabled device,
such as a Blu-ray player, game console, DVR, or smart
TV, to your wireless network.
First, connect the Range Extender to your Wi-Fi
network following the instructions in Option 1 or
Option 2, then connect an Ethernet-enabled device
to the Range Extender using an Ethernet cable as
shown in the diagram on the right.
All manuals and user guides at all-guides.com
2 Connect
A. Press the WPS button on your router/AP.
For more information about using WPS on your router,
please refer to the router manufacturer's user guide.
YourNetworkName
and password
The Range Extender shares your router's Wi-Fi password for both 2.4GHz and 5GHz networks, but may have di erent wireless
network names if you customize the names during the con guration.
Keep away from
Ethernet Connection
Smart TV Game Console
LEDs
(WPS)
Flashing green: The Range Extender is
establishing a secure connection or being
con gured via web page.
Solid green: The Range Extender has established
a secure connection, and the signal strength is
adequate.
Solid orange: The Range Extender has established
a secure connection, but the signal strength is
too strong.
Solid red: The Range Extender has established a
secure connection, but the signal strength is too
weak.
O : No active connection.
B. Immediately push the RE button on your Range
Extender.
If the RE LED does not switch from blinking to a solid green,
please refer to Option 2.
5G
2.4G
Ideal Range Extender Placement
Desktop
(2.4G)
On: The Range Extender is connected to the 2.4G
wireless network of your main Router/AP.
O : The Range Extender isn't connected to your
main Router/AP.
(5G)
On: The Range Extender is connected to the 5G
wireless network of your main Router/AP.
O : The Range Extender isn't connected to your
main Router/AP.
(Power)
On: The Range Extender is on.
O : The Range Extender is o .
Flashing: The Range Extender is initializing.
The " " LED should change from
ashing to solid, showing that WPS
connection was successful.
YourNetworkName or
YourNetworkName_EXT
and password
Enjoy!
Wireless Connection
Laptop Smartphone Tablet