Page 1
2022/01/06 FIRETRACKER FT128 FIRE ALARM SYSTEM QUICK OPERATION GUIDE 1 - TO SILENCE PANEL BUZZER: Press Button once to silence panel buzzer. Caution. Pressing the Button again will cause the buzzer to resound. 2 -TO SILENCE ALARM DEVICES: Press Button once to silence all alarm devices, sounders or Occupant Warning System (OWS) and wait for a few seconds.
Page 2
2022/01/06 4 - TO DISABLE (ISOLATE) AN ACTIVE ALARM: IMPORTANT: Alarm devices must be silenced before pressing “Disable” button. Button to isolate device in alarm – system will now illuminate the Press LED. This zone / address point will remain disabled until manual re- enabled via Menu H2/B6 button.
Page 3
2022/01/06 7 - TO MANUALLY RE-ENABLE AN ALARM POINT FROM THE MENU: 1. Press Button. 2. Key Enter Access Code. 3. Scroll to the Disable or re-enable menu (H2) by pressing button/s then press to Accept a. RE-ENABLE SINGLE POINT Scroll to the Re-enable address menu (B5) by pressing button/s then press...
Page 4
2022/01/06 10 – TO ACKNOWLEDGE FAULT 1. Press Button. 2. Key Enter Access Code. 3. Scroll to the Acknowledge Fault menu (H6) by pressing Button/s then press Accept 4. Scroll to check the list of faults by pressing Button/s then press to Access the fault.
Page 5
2022/01/06 FAULT: High current on COM-loop Page: 66 FAULT: Input Page: 66 FAULT: Input x exp board x Page: 67 FAULT: Interlocking input AA/PP Page: 67 FAULT: Loop unit zz - aa ? Page: 67 FAULT: Loop unit techn. address xxx ? Page: 67 FAULT: Low battery capacity Page: 67...
Page 6
2022/01/06 13 – OPERATION MANUAL FT128 Rev 2.4 Scan QR code to Search instructions and other relevant operational procedures. Software download Restart Perform Monthly test (H1) Disable and re-enable (H2) Set Calendar and Clock (H3) Present System Status (H4) Service (H5) Acknowledge Faults (H6) Perform Zone Test (Test Mode) (H7) Maintenance (H8)