Table of Contents
Advertisement
Quick Links
User Manual
ATS - 90 7 | 9 08 | 9 0 9 | 10 0 0
This Product should be installed according to this manual.
Please read this manual carefully and install properly.
Please keep this manual for future reference.
Please register Warranty for proper service.
Supreme...
HYGIENE AND COMFORT
www.LotusSeats.com
Lotus Hygiene Systems Inc.
Advertisement
Table of Contents
Related Manuals for Lotus ATS-907
Summary of Contents for Lotus ATS-907
- Page 1 ATS - 90 7 | 9 08 | 9 0 9 | 10 0 0 This Product should be installed according to this manual. Please read this manual carefully and install properly. Please keep this manual for future reference. Please register Warranty for proper service. Supreme... HYGIENE AND COMFORT www.LotusSeats.com Lotus Hygiene Systems Inc.
-
Page 3: Table Of Contents
Contents IMPORTANT SAFEGUARDS / GENERAL CAUTIONS CAUTIONS BEFORE INSTALLATION IDENTIFICATION OPERATION (BASIC) OPERATION (DETAILED) IDENTIFICATION OPERATION (BASIC) OPERATION (DETAILED) INSTALLATION SEPERATION OF THE UNIT FROM THE TOILET BOWL MAINTENANCE WATER DRAINING TROUBLE SHOOTING SPECIFICATIONS INFORMATION TO THE USER WARRANTY Installation Manual and Operating Instructions... -
Page 4: Important Safeguards
IMPORTANT SAFEGUARDS/GENERAL CAUTIONS READ ALL INSTRUCTIONS BEFORE INSTALLATION AND USE The following terms are used in this manual to indicate hazards of varying degrees of severity indicates an imminently hazardous situation which, if not avoided, will result in death DANGER or serious injury. - Page 5 Do not plug in the power cord before connecting the water supply hose. Prohibited This product must be grounded before use. Refer to the grounding instructions on page 7. A Ground Fault Circuit Interrupt (GFCI) outlet is highly recommended. Grounding Do not splash water on this product.
-
Page 6: Cautions Before Installation
CAUTION Never operate this product if it is Do not obstruct or not working properly, if it has put anything into the been dropped or damaged, or dry air outlet. Do not dropped into water. Return the apply excessive force product to a service center for to the nozzle. - Page 7 GROUND INSTRUCTIONS This product has a three-prong grounding plug, which must be plugged into an outlet that is properly installed and grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current. If repair or replacement of the cord or plug is necessary, do not connect the grounding wire to either flat blade terminal.
-
Page 8: Identification
IDENTIFICATION MAIN UNIT Warning Label (Caution Label) WASH LADY Control Panel Operation LED Window Deodorizer (ATS-909L/R) Dryer Outlet WASH LADY Drain / Unit Separation Button Digital Occupied Sensor (Seat Sensor) Heated Seat IN THE BOX Water Supply Tube to Washer SHS unit (SMART HYGIENE SEAT) (2 pcs) T- Valve... -
Page 9: Operation (Basic)
OPERATION (BASIC) Stop all operations Wash (Anal Wash) Lady (Vaginal Wash) Warm Air Dryer Nozzle move back and Rhythm wash forth Adjust the oscillation Adjust the water pressure function and nozzle air dryer temperature. position (5 levels). Adjust the water seat temperature (3 levels). -
Page 10: Operation (Detailed)
OPERATION (DETAILED) PREPARATION Check for any water leaks. Plug the unit into the proper power source and the RED LED power light will start flashing. Wait until the RED LED power light stops flashing and becomes solid red. The water tank will be filled after pushing a “Wash” ( )button. - Page 11 WARM AIR DRYER Press “Dry ”, to turn on dryer. Adjust the warm air temperature with “High ” and “Low ” button. The dryer automatically stop in 3 minutes. Warmer Cooler WATER PRESSURE / DRYER TEMPERATURE ADJUSTMENT After sitting down on the seat, the LED lamp( ) for water pressure should light at 3 levels( ).
- Page 12 OPERATION (DETAILED) NOZZLE POSITION ADJUSTMENT Nozzle position is adjustable to the desired position by pressing “( )” or “( )”button. After use the nozzle will return to position 3. DEODORIZER (ATS-909L, R Only) The deodorizer is activated when the unit is occupied. It automatically stops in about 1 minute after user leaves.
- Page 13 MASSAGE (Rhythm Wash) In using “WASH” or “LADY” mode, pressing “MASSAGE“button will provide pulsating spray. In addition, the water pressure can be adjusted by pushing "( ) High or ( Low" and "MASSAGE", simultaneously. * Auto-Setting of Massage : Without occupying the seat, press “MASSAGE” button for 3 seconds to set up Auto-Setting of “MASSAGE”.
-
Page 14: Identification
IDENTIFICATION (ATS-1000) MAIN UNIT Warning Label (Caution Label) Wash Lady Simpe Operation Panel Operation LED Window Deodorizer (ATS-1000L/R) Dryer Outlet Wash Lady Drain / Unit Separation Button Digital Occupied Sensor (Seat Sensor) Heated Seat IN THE BOX Washer Deodorizer Filter Unit Water Supply Tube to (2 pcs) SHS unit (SMART HYGIENE SEAT) -
Page 15: Operation (Basic)
OPERATION (BASIC) STOP WASH LADY WASH LADY PURE DRYER DRYER STREAM HIGH SEAT Adjust the water and seat Adjust the oscillation function temperature (4 levels). and nozzle position (5 levels). OSCILLATE MASSAGE WATER Adjust the water pressure and warm air dryer temperature. -
Page 16: Operation (Detailed)
OPERATION (DETAILED) PREPARATION Check for any water leaks. Plug the unit into the proper power source and the RED LED power light will start flashing. Wait until the RED LED power light stops flashing and becomes solid red. The water tank will be filled after pushing a “Wash” ( )button on the simple operation panel. - Page 17 WARM AIR DRYER Press “Dry ”, to turn on dryer. Adjust the warm air temperature with “High ” and “Low ” button. The dryer automatically stop in 3 minutes. Warmer Cooler WATER PRESSURE / DRYER TEMPERATURE ADJUSTMENT After sitting down on the seat, the LED lamp( ) for water pressure should light at 3 levels( ).
- Page 18 OPERATION (DETAILED) NOZZLE POSITION ADJUSTMENT Nozzle position is adjustable to the desired position by pressing “( )” or “( )”button. After use the nozzle will return to position 3. DEODORIZER (ATS-1000L, R Only) The deodorizer is activated when the unit is occupied. It automatically stops in about 1 minute after user leaves.
- Page 19 MASSAGE (Rhythm Wash) In using “WASH ( )” or “LADY ( )” mode, pressing “MASSAGE“button will provide pulsating spray. In addition, the water pressure can be adjusted by pushing "( ) High or ( ) Low" and "MASSAGE", simultaneously. * Auto-Setting of Massage : Without occupying the seat, press “MASSAGE”...
-
Page 20: Installation
INSTALLATION CAUTION BEFORE INSTALLATION Please, do not plug in before installation. If you need an electric power outlet or extension, please consult a qualified electrician. STEPS Shut off water supply then flush Connect T-Valve. toilet. Remove the water supply Install T-Valve as shown. hose to toilet tank (Part A). - Page 21 Put the BOLT into METAL BOLT CASE and align with the top of the BASE PLATE. Insert BOLT with METAL BOLT CASE onto the BASE PLATE. Metal Bolt Case Bolt Bolt Metal Bolt Case Base plate DO NOT MOUNT Base Plate to toilet bowl. Follow step 6. Flip the base plate with bolt/metal Install the main unit and insert the bolt case upside-down and slide into...
- Page 22 Reset Test Turn on water valve. Plug into power outlet. Diagram A Power Red LED blinking ATS-907,908,909 Models ATS-1000 Model WASH (Simple side control) Without sitting on seat, push rear soft to fill Diagram B water tank completely. Water tank will start Power Red LED solid filling and making a beeping sound.
-
Page 23: Seperation Of The Unit From
SEAT WATER Please wait five minutes and once you feel the Once the water tank is full, push the water and seat/water is hot then the unit is ready to be seat temperature button to red LED. adjusted to your desired temperature SEPARATION OF UNIT FROM THE TOILET BOWL In case you need to remove the SHS unit from the toilet bowl,... -
Page 24: Maintenance
MAINTENANCE CLEANING THE NOZZLE In case the nozzle is soiled and needs to be cleaned, press “WASH”( ) button for 3 seconds without occupying the seat, the nozzle will extend out without spraying water. After cleaning, Press “STOP”( ) button to retract nozzle. -
Page 25: Water Draining
WATER DRAINING DRAIN THE WARM WATER TANK IN THE UNIT If you are going to leave the unit unused for a long time, please drain water from the unit’s warm water tank. 1) Disconnect the power plug. Existing Flexible Tube (The water supply hose) 2) Close the shut off valve. -
Page 26: Trouble Shooting
TROUBLE SHOOTING Trouble Cause Remedy 1. The water tank is not filled. 1. Wait about one minute. The water does 2. The shutoff valve is closed. 2. Press the desired washing not spray 3. Freezing inside the main unit button once again. or the water supply pipe. -
Page 27: Specifications
SPECIFICATIONS Specifications ATS-907 ATS-908 ATS-909 ATS-1000 Power Rating AC 120V 60Hz 660W Type Direct Inlet flow type Water inlet type Water inlet pressure 0.4 ~ 7.5 kgf/cm2(5.69 psi ~ 106.7psi) Power cord 1.2m (4 feet) WASH Max. 1.2ℓ/min ( Max. 0.32 GPM) Max. -
Page 28: Information To The User
Lotus Hygiene Systems Inc. replacement will be warranted to the original purchaser of the products. -
Page 29: Warranty
11. Damage from misuse due to not following the installation manual. WARRANTY REGISTRATION PLACE To ensure your warranty protection you must complete and return this card STAMP to Lotus Hygiene Systems Inc. within 15 days after date of purchase. HERE Serial Number # Model Purchaser... - Page 30 1.877.808.0055 www.LotusSeats.com Inquiries and Support Lotus Hygiene Systems Inc. 1621 E. St. Andrew Pl., Santa Ana, CA 92705 1.877.808.0055 www.LotusSeats.com...