Toro Z Master Professional 7500-D Series Operator's Manual page 72

1. Upper pivot point bushing
2. Lower pivot point bolt
15. Apply a thin bead of Loctite
circumference of the rear edge of the new
bushings.
16. Insert and gently tap the new bushings into the
opening and properly seat them into place.
17. Place a block of wood under the inside edge of
the center deck to make it easier to work on the
lower pivot point bushings.
18. Remove and retain the lower pivot point bolts
(Figure 83 and Figure
19. Remove and discard the flanged bushing from
the front and rear of the wing deck and clean
the bore.
20. Apply a thin bead of Loctite
circumference of the rear edge of the new
bushings.
21. Insert and gently tap the new bushings into the
opening and properly seat them into place.
22. Install the lower deck pin assemblies and bolts
into the lower deck pivot points and hand-tighten.
23. To ease installing the wing deck sections,
carefully remove the exposed end of the spring
that applies pressure to the rear of the wing
deck cover (Figure
Figure 86
3. Deck pin assembly
4. Bushing
® 680 to the entire
86).
® 680 to the entire
87).
g351363
1. Spring
24. Push the left wing deck back to the center deck.
Align and install the upper pivot deck pins in the
front and rear of the deck and secure it using the
previously removed bolts
25. Align the lift-cylinder arm and install the
previously removed pin and ensure that the
locking tab aligns with the associated opening
in the mount.
Install the locking cotter pin to secure.
26. Attach the spring that was removed in step
that applies pressure to the rear of the wing
deck cover.
27. Install the wing deck belts.
28. Install the wing deck belt shields and secure
them using the lynch pins.
29. Raise the wing decks to the T
and secure them using the clevis pins and
hairpin cotters.
30. Install the height-of-cut pin.
72
Figure 87
(Figure 85).
RANSPORT
g351417
23
position