Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Teka VIROLINE TOWER
Summary of Contents for Teka VIROLINE TOWER
- Page 1 Operating instructions (Translation of the original operating instructions) VIROLINE TOWER TEKA Absaug- und Entsorgungstechnologie GmbH, Millenkamp 9, D-48653 Coesfeld, Tel.: +49 2541-84841-0, E-Mail: info@teka.eu, www.teka.eu...
-
Page 2: Table Of Contents
Table of contents 1. General 2. Description of the system elements 2.1. Illustration of the system elements 2.2. Functionality of the system 2.3. Intended use 3. Safety instructions 3.1. Definition of the hazard symbols 3.2. General safety instructions 4. Storage, transport and installation of the device 5. -
Page 3: General
14.2.3. Electrical test of the electrical lines and earthing connections 1. General Congratulations on purchasing the product from TEKA. Our engineers ensure that our devices reflect the state of the art through continuous development. Nevertheless, misuse or misconduct can endanger your safety. Please observe the following for a... -
Page 4: Description Of The System Elements
2. Description of the system elements 2.1. Illustration of the system elements Installation example: Z.Nr. 20434701 Pos.1 Operating panel of the control Pos.10 UV-C lamp Pos.2 Particle filter housing Pos.11 Mains cable with plug Pos.3 Fan housing Pos.12 Forklift skids Pos.4 Lamp housing Pos.13... -
Page 5: Functionality Of The System
2.2. Functionality of the system At a height of over three metres, the contaminated air is sucked in and is guided through a UV-C irradiation section. Surviving germs that have not been directly killed by the UV-C light are caught by the H14 filter and are then eliminated by continuous exposure to UV-C irradiation. -
Page 6: General Safety Instructions
3.2. General safety instructions WARNING Dangers arising from improper use / unauthorised operations. The operator must ensure that their authorised personnel are familiar with all the safety indications in this manual in advance. The operator is responsible for ensuring that all work is carried out by authorised and qualified personnel. -
Page 7: Storage, Transport And Installation Of The Device
4. Storage, transport and installation of the device WARNING Risk of injury from tilting or unmounted components when stored or transported. The device must be secured against tilting and slipping when it is stored or transported. Do not stand under or next to the floating load. Lift trucks, forklift trucks and transport cranes must have a sufficient minimum load bearing capacity. -
Page 8: Commissioning
5. Commissioning WARNING Dangers arising from a defective condition of the unit. There is also a risk to the eyes if there is a direct view of the UV-C lamp. Make sure that the measures described in this chapter are completed before the commissioning of the unit. -
Page 9: Operating The System
6. Operating the system 6.1. Explanation of the operating elements Operating elements for the device control Representa Designation Description / function tion ON-OFF-switch The switch switches the fan / UV-C lamps on and off. (2x) When the device is switched off, it is not disconnected from the power supply. -
Page 10: Maintenance
7. Maintenance In accordance with national regulations, the operator is obliged to carry out repeat and functional tests. Unless otherwise specified by national regulations, we recommend regular visual inspections and functional tests of the device as described in the chapter “Maintenance intervals”. You find the chapter “Maintenance intervals”... -
Page 11: Reset To Maintenance State
Remove the prefilter mat (B) from the insert frame (C) and dispose of or store it according to the regulations. ● Put a new prefilter mat into the insert frame. Only use TEKA spare filters. Otherwise the proper functioning of the unit is not guaranteed. ● Assemble the locking plate again with the 3 screws. -
Page 12: Replacing The Particle Filter
Carefully pull the particle filter (see chapter 2.1) out of the housing. ● Push the new particle filter back into the particle filter housing. Only use TEKA spare filters. Otherwise the proper functioning of the unit is not guaranteed. ●... -
Page 13: Recplacing The Uv-C Lamp
Now carefully pull all the UV-C lamps (A) out from their sockets (B). To do this, the UV-C lamp must also be released from the holder (C). ● Insert the new UV-C lamps. Only use TEKA spare parts. Otherwise the proper functioning of the unit is not guaranteed. ● Close the service door. -
Page 14: Dismantling / Disposal
8. Dismantling / Disposal Only authorised personnel may disassemble the machine. WARNING Dangers arising from electricity. Before the dismantling of the machine it has to be disconnected from the power supply and all supply lines. CAUTION Whirling up dust is possible due to the deposited dust. During all work a suitable respiratory protection and protective clothing have to be worn. -
Page 15: Diagnostics And Troubleshooting
A recommissioning of the device must only occur if it is ensured that the system is functionally equivalent to the original state. Repairs may only be carried out by TEKA personnel or, after consultation with TEKA GmbH, by the personnel authorised by the operator. -
Page 16: Technical Data
11. Technical data Supply voltage Frequency Type of current Engine power 0,55 Air flow volume max. m³/h 3000 Protection class IP54 ISO class Width Depth Height 3200 Weight Sound pressure level dB(A) Allowed ambient temperature °C +5 to +35 (during operations) -10 to +40 (during transport and storage) Allowed max. -
Page 17: Ec Declaration Of Conformity
This declaration will become void if the device is exposed to modifications that are not approved by the manufacturer in written form. Authorized representative for the technical documentation: TEKA Absaug- und Entsorgungstechnologie GmbH, Millenkamp 9, D-48653 Coesfeld (Jürgen Kemper, managing director) Coesfeld, 4th january 2021 BA_VIROLINE-TOWER_201111_EN 12.01.2022... -
Page 18: Training Protocol
13. Training protocol Designation of the device: VIROLINE TOWER (This form can be used by the operator to document the training of the employees. Training should be performed by authorized personnel only. Refer to the instructions in Chapter "Safety Instructions") -
Page 19: Maintenance Intervals
The approach of the maintenance measures is described in chapter "Maintenance". Maintenance interval Maintenance work Chapter recommended by TEKA determined by the operator The saturation of the particle filter is automatically monitored by the filter unit and thus is not subject to a maintenance interval. -
Page 20: Visual Inspection Of The Device
14.2.1. Visual inspection of the device Visual inspection: Observation that there are no visible safety-related defects. WARNING Danger arising from the ready to operate condition of the device. Follow the procedure as described in the chapter “Set to maintenance state”. The following steps must be carried out in the course of the visual inspection: ●...
Need help?
Do you have a question about the VIROLINE TOWER and is the answer not in the manual?
Questions and answers