1. Manuals
  2. Brands
  3. GTO Manuals
  4. Locks
  5. FM145
  6. Installation manual

GTO FM145 Installation Manual

Gto fm145 automatic gate lock: install guide
Hide thumbs Also See for FM145:
1
2
3
4
5
6
7
8
9

Advertisement

Table of Contents

Installation Manual

PLEASE NOTE ... due to the variety of possible mounting applications, no mount-
ing hardware for the lock is provided. All necessary mounting hardware can be
obtained at a local hardware store; all other hardware is provided. If you need assis-
tance please call GTO
Contents
• Before You Start ----------------------------------- page 1
• Parts Identification -------------------------------- page 2
• Mounting the Lock -------------------------------- page 3
• Wiring the Control Board ------------------------- page 6
• Accessory and Warranty Information ----------- inside back cover
RB920 ... rev- 5/20/03
PEDESTRIAN GATE LOCK
Technical Service at 800-543-1236.
®
8
®
, Inc.
TM

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FM145 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for GTO FM145

Summary of Contents for GTO FM145

  • Page 1: Installation Manual

    PLEASE NOTE ... due to the variety of possible mounting applications, no mount- ing hardware for the lock is provided. All necessary mounting hardware can be obtained at a local hardware store; all other hardware is provided. If you need assis- tance please call GTO ® Contents •...

  • Page 2: Before You Start

    • For greater security, use the GTO Digital Keypad for entry control (see inside back cover). We strongly recommend using the Digital Keypad on swimming pool and daycare gates to help prevent children from activating lock release.

  • Page 3: Parts Identification

    Parts Identification P (top) P (side) O (top) O (side) A - Lock w/ 20' of Low Voltage Wire B - Lock Receiver C - Clevis Pin D - Locking Cap E - Control Box F - Lock Control Board G -12 Volt DC Charger H -Battery Lead Wires I - Ten (10) ft.

  • Page 4: Mounting The Lock

    Mounting The Lock: Step 1: With the gate in the closed position determine the best location for the lock and receiver. Attach the lock to a solid surface or cross member to provide stability. Step 2: Hold receiver and lock together (with receiver pin hole and lock slot aligned) against the gate post and mark positions to drill receiver holes (see Illustration C &...
  • Page 5 Illustration C Iron or Aluminum Tube Fence and Gate Installation Remember to check the alignment and mark positions before drilling holes in fence post and gate. Clevis Pin Receiver Locking Cap Illustration D Chain Link Fence and Gate Installation Remember to check the alignment and mark positions before drilling holes in fence post .
  • Page 6 (lock stays open longer). Manual Lock Release The Bulldog Automatic Gate Lock has a keyed manual lock release. If the electronic lock release becomes disabled for any reason, simply use the key to manually open the lock. In the event you should need to use the key.

  • Page 7: Wiring The Control Board

    #1 and the #5 control board terminals (follow the instructions for individual device for correct polar- ity). The push button which is included with the Bulldog has no polarity. If you use the GTO Digital Keypad connect the wire from the WHT (Normally Open) terminal on the keypad to the #5 termi- nal on the lock control board.

  • Page 8: Available Accessories

    Products received at the factory without an RGA will not be accepted. Replacement or repaired parts are covered by this warranty for six (6) months or the remainder of the two (2) year warranty period. GTO, Inc. will pay the shipping charges for return to the owner of items repaired.

Table of Contents