Crown CEM-1524 Instruction Manual page 20

Note: During operation, if the green indicator is extinguished, you should turn the steam control knob to
OFF position. Then press and release the coffee/steam button to the higher position which is
the position and press down the pump control to the lower position which is the "
pump water, after about 30s, close the pump, press down the coffee/steam button to the lower position
which is the position again, then wait for until the green indicator is illuminated and turn the steam
control knob in anti-clockwise, the steam will come out again.
3. Fill a jug with about 100 grams of milk for each cappuccino to be prepared, you are recommended to use
whole milk at refrigerator temperature (not hot!).
Note: In choosing the size of jug, it is recommend the diameter is not less than 70 ± 5mm, and bear in
mind that the milk increases in volume by 2 times, make sure the height of jug is enough.
4. Insert the frothing device into the milk about two centimetre, then turn the steam control knob slowly in
anti-clockwise, steam will come out from the frothing device. Froth milk in the way moving vessel round
from up to down.
Note: Never turn the steam control button rapidly, as the steam will accumulate rapidly in short time
which may increase the potential of the risk of explosion.
5. When the required purpose is reached, you can turn the steam control knob to the minimum position.
Note: Clean steam outlet with wet sponge immediately after steam stops generating, but care not to hurt!
6. Pour the frothed milk into the espresso prepared, now the cappuccino is ready. Sweeten to taste and if
desired, sprinkle the froth with a little cocoa powder.
7. Press and release the
Note: we recommend you allow the maker to cool down at least for 5 min before making coffee again.
Otherwise burnt odor may occurred in your Espresso coffee .
PRODUCING STEAM TO HEAT LIQUIDS
The steam wand (without the frothing device) can be used to make hot beverages like drinking chocolate,
water or tea.
Method:
1. Remove the detachable tank and fill it with desired water, the water level should not exceed the "MAX"
mark in the tank. Then place the tank into the appliance properly.
2. Then connecting the appliance to power supply source.
to cut the power source off.
ON/OFF button
" position and