Table of Contents
Advertisement
Unlock the Packaging Locks
Rotate the packaging locks 90
degrees counterclockwise.
Pull out the packaging locks and
discard.
GETTING STARTED
BATTERY REMOVAL AND INSTALLATION
1. Make sure the unit is turned Off.
2. Find the battery cover located on the back of the unit, use a
screwdriver to loosen the screw and then open the battery cover.
3. Remove old batteries by pulling up on one end of each
battery.
4. Install 2 new AA (AM-3/LR6) batteries following the diagram
inside the battery box. (For best performance, alkaline
batteries or fully charged Ni-MH rechargeable batteries are
recommended.)
5. Replace the battery cover and tighten the screw to secure.
4
Advertisement
Table of Contents
