Getting Started - LeapFrog Tap-a-Peg Wooden Truck Instruction Manual

GETTING STARTED

Battery Removal and Installation
1. Make sure the unit is turned Off
2. Find the battery cover located on the back of the unit, use a
screwdriver to loosen the screw and then open the battery
cover.
3. Remove old batteries by pulling up on one end of each
battery.
4. Install 3 new AAA (AM-4/LR03) batteries following the
diagram inside the battery box. (For best performance,
alkaline batteries or fully charged Ni-MH rechargeable
batteries are recommended.)
5. Replace the battery cover and tighten the screw to secure.
WA R N IN G :
Adult assembly required for battery installation.
Keep batteries out of reach of children.
AT T E N T I ON :
Les piles ou accumulateurs doivent être installés par un
adulte. Tenir les piles ou accumulateurs hors de portée des
enfants.
Off.
4