Nokia HH-12 Manual page 4

Check that the deployment of the
airbag is not blocked or impaired
in any way.
Ensure that the mounting device
or mobile holder is not installed
where you might come in contact
with it in the event of an accident
or collision.
Periodically check that the suction
cup at the bottom of the
mounting device is firmly
Attach to a windshield
Locate a safe mounting surface on
the windshield, and clean the
surface thoroughly with a glass
cleaner and a clean towel. If the
ambient temperature is below
+15°C (60°F), carefully warm the
surface and the suction cup with
a hair dryer to ensure a firm grip
on the windshield. Ensure that
4
attached to the windshield,
especially if the ambient
temperature changes a lot.
Never leave the mounting device
inside the vehicle in direct
sunlight or in excessive heat. The
mounting device and suction cup
may be damaged and adhesion
may be impaired if the inside
temperature exceeds +70°C
(160°F).
you do not heat the windshield
excessively to avoid damage to it.
Press the suction cup at the
bottom of the mounting device
firmly on the windshield (see step
1 at the start of this guide), and
carefully push the locking lever
inside the mounting device (2)
towards the suction cup to create
© 2008 Nokia. All rights reserved.