Maintenance And Cleaning; Cleaning The Product; Disposal; Warranty - Silvercrest SGS 600 A1 Operation And Safety Notes

Set-up / Maintenance and cleaning / Disposal / Warranty
soon start coming out of the steam chamber
With the water tank
midify the air for approx. 30 minutes.
ATTENTION! RISK OF SCALDING! Always
keep a minimum distance of 25 cm from the
steam chamber
7
S et the rotary switch
the product off again.
D iscard any water remaining in the water res-
ervoir after use to prevent the growth of
2
bacteria. To do so, allow the product to cool
down, remove the water tank
product so water can drain out of the water
reservoir .
2

Maintenance and cleaning

A lways unplug from the socket before maintain-
ing and cleaning the product.

Cleaning the product

D o not use aggressive chemicals or scouring
agents.
C lean the housing
C lean the inside of the housing about once a
month to prevent limescale and bad odours.
T o do so, fill the water tank
vinegar (50 % each).
Connect the mains plug to the mains socket.
S et the rotary switch
of the rotary switch will light up blue. After ap-
prox. 1 minute steam will come out of the steam
chamber .
7
R un the device for approx. 15 minutes.
S et the rotary switch
the product off again.
T hen unplug from the socket.
N ow remove the water tank
chamber and fill the housing
7
water.
C lean the inside of the housing with a soft sponge.
T hen discard the water from the housing
and place it upside down to dry, e.g. on a dish
drying rack. The inside of the device must be
completely dry before using the device again.
24 GB/IE
full the product will hu-
1
.
to position to switch
5
and tip the
1
with a soft, dry cloth.
6
with water and
1
to position . The edge
5
to position to switch
5
and the steam
1
with clean
6
6

Disposal

.
7
The packaging is made entirely of recyclable
materials, which you may dispose of at local
recycling facilities.
Observe the marking of the packaging
materials for waste separation, which
b
a
are marked with abbreviations (a) and
numbers (b) with following meaning:
1–7: plastics / 20–22: paper and fibre-
board / 80–98: composite materials.
The product and packaging materials
are recyclable, dispose of it separately
for better waste treatment. The Triman
logo is valid in France only.
Contact your local refuse disposal author-
ity for more details of how to dispose of
your worn-out product.
To help protect the environment, please
dispose of the product properly when it
has reached the end of its useful life and
not in the household waste. Information
on collection points and their opening
hours can be obtained from your local
authority.

Warranty

Dear Customer,
This device is sold with three years warranty from the
date of purchase. In the event of product defects, you
have legal rights towards the seller. These statutory
rights are not restricted by our warranty as described
below.

Warranty conditions

The warranty period commences upon the date of
purchase. Please keep the original receipt in a safe
place as it is required as proof of purchase. If any
material or manufacturing faults occur within three
years of purchase of this product, we will repair or