Craftsman CMGSB24208 Instruction Manual page 21

Auger Control
AUGER
CONTROL
The auger control is located on the left handle. Squeeze the control grip against the
handle to engage the auger and start snow throwing action. Release to stop.
Refer to the Auger Control information in the Assembly & Set-Up section
IMPORTANT:
prior to operating your snow blower. Read and follow all instructions carefully and
perform all adjustments to verify your snow blower is operating safely and properly.
Drive Control/ Auger Control Lock*
DRIVE
CONTROL
The drive control is located on the right handle. Squeeze the control grip against the
handle to engage the wheel drive. Release to stop.
*On select models, the drive control also locks the auger control so you can operate
the chute directional control without interrupting the snow throwing process. If the
auger control is engaged simultaneously with the drive control, the operator can
release the auger control (on the left handle) and the augers will remain engaged.
Release both controls to stop the augers and wheel drive.
NOTE: Always release the drive control before changing speeds. Failure to do so will
result in increased wear on your machine's drive system.
OPERATION
GO
GO
21
Overhead Chute Directional Control (If Equipped)
CHUTE DIRECTIONAL CONTROL
DISCHARGE
LEFT
The overhead chute directional control is located in the center of the snow blower
between the handle panel and lower handle. To change the direction in which snow
is thrown, rotate the chute directional control.
Two-Way Chute Control (If Equipped)
The two-way chute control (Joystick) is located on the left side of the handle panel.
• To change the direction in which snow is thrown, squeeze the button on the
chute control lever and pivot the chute control lever to the right or to the
left.
ADJUSTABLE
CHUTE TILT
DISCHARGE
RIGHT