Craftsman CMGSB24208 Instruction Manual page 12

4. Insert chute control rod into the support bracket on rear of the dash panel.
See Figure 16.
5. Remove hairpin clip (a) from rear of chute control head. See Figure 17.
6. Insert chute control rod (b) into rear of chute control head. See Figure 17.
Secure chute control rod to chute control assembly with hairpin clip removed
in Step 5.
Continue to Set-Up (page 16).
Figure 16
Figure 17
STOP
ASSEMBLY
2-Way & 4-Way Chute Control
1. Remove hairpin clip, wing nut and hex screw from chute control head and
clevis pin and bow-tie cotter pin from chute support bracket. See Figure 19.
Chute
Chute Base
12
Figure 18
Chute Control Head
Chute Support
Bracket
Figure 19