Power Management; Cold Weather Operation; Maintenance; Pre-Operation Steps - Jegs 86004 Manual

Operation Cont.
Never exceed the generator's wattage /
amperage capacity. This could damage
the generator and / or connected devices.
3-in-1 Meter
The multifunction meter operates whenever the
engine is running and keeps track of how many
hours, frequency, and voltage is being used on
the generator.

Power Management

• Start the engine without anything connected to
the generator.
• When the engine has stabilized, plug in and turn
on first load. It is strongly recommended to plug
in devices with the largest power requirement
first and the smallest power requirement last to
help prevent overloading the generator.
• Allow generator output to stabilize (engine and
attached devices run evenly) before plugging in
the next load.

Cold Weather Operation

Under humid conditions where temperatures drop to
40ºF (4ºC) the carburetor and/or crankcase breather
system may begin to freeze. To prevent icing take
the following steps:
• Replace any old fuel with clean, fresh fuel.
• Use synthetic 5W-30 or SAE 5W-30 engine oil.
Check oil daily or after every 8 hours of use.
• Ensure generator is serviced according to the
maintenance schedule under "Maintenance"
section of manual.
• Shelter unit from elements.

Maintenance

Regular Maintenance
Regular maintenance will extend the life of this unit
and improve its performance. The warranty does
not cover items that result from operator negligence,
misuse, or abuse. To receive full value from the
warranty, operator must maintain the generator as
instructed in this manual, including proper storage.

Pre-Operation Steps

Before starting the engine, perform the following
pre-operation steps:
• Check the level of the engine oil and the fuel
gauge level. Add oil or fuel as needed.
• Make sure the air filter is clean.
• Remove any debris that has collected on the
generator and around the muffler and controls.
Use a vacuum cleaner to pick up loose debris. If
dirt is caked on, use a soft bristle brush.
• Inspect the work area for hazards.
After Each Use
Follow the following procedure after each use:
• Shut off engine.
• Store unit in a clean and dry area.
Before inspecting or servicing this
machine, make sure the engine is off and
no parts are moving. Disconnect the spark plug
wire and move it away from the spark plug.
14