Remington POWERHAMMER 476 Operating Instructions Manual page 18

Operation
6. After the fastening is made, remove
the tool from the work surface. Grab
the barrel and pull forward rapidly.
This ejects the spent load and sets
the piston in the firing position.
7. NOTE: THE TOOL CANNOT BE
FIRED IN THE OVERHEAD POSI-
TION.
PISTON OVERDRIVE
If the tool does not open after firing
and the piston is 12.7mm (1/2 "), or more
out of the muzzle:
1. Place the muzzle end of the tool
against wooden work surface and
hold grip with one hand.
2. Hit the firing pin with a hard hammer
blow several times and force piston
back into muzzle.
3. Eject the power load. (See step 6 of
Firing The POWERHAMMER  ).
CARE OF YOUR POWERHAMMER
Clean your Powerhammer after
each day's use. Clean chamber with
accessory wire brush, part number
56485. Apply good quality penetrating
lubricant spray (such as WD-40) spar-
ingly and wipe dry.
Accessories
Part No.
56485
56415
TA4090
NOTE: The labor regulations of many
communities require that the operator of
this tool on a job site be thoroughly
trained and certified for compentence
prior to operating this tool. Contact SGB
Youngman or the nearest distributor for
trainings.
OVERDRIVE
Description
Brush, .25
Goggles
Shield, Spall
18