Force Recovery Mode - Avermedia NX215 Manual

$ sudo su
$ gpio_id=232
$ echo $gpio_id >/sys/class/gpio/unexport
For L4T (Linux for Tegra) BSP support and the other software support associated with
NVIDIA® Jetson Nano / TX2 NX/ Xavier NX , please visit AVerMedia website to contact
our technical support function. (https://www.avermedia.com/tw/support/contact)

7.0 Force Recovery Mode

USB 3.l/ Jetson platform
NVIDIA® Jetson NANO/TX2 NX/Xavier NX by using the other host system running NVIDIA
Jetpack, as the procedure described below.
1. Power off the system. Ensure the system power must be completely OFF, instead of staying
in the suspend mode or the sleep mode.
2. Connect a USB cable from
used to re-program the new system file into NVIDIA® Jetson NANO/TX2 NX/Xavier NX.
3. Press and hold down Force Recovery Button and then power on the carrier board.
4. After three seconds, release Force Recovery Button.
5. NVIDIA® NANO/TX2 NX/Xavier NX will show up on the USB list of the host system as a
new NVIDIA target device.
6. After the system software is updated successfully, please ensure to power off the system. A
clean power-on will then revert
port of NX215/NO115B/TN115B/NX215B can be used to re-program
Jetson platform
Jetson platform
NX215/NO115B/TN115B/NX215B User Manual
AVerMedia Technologies, Inc www.avermedia.com
USB port to the other host system which will be
port back to the host mode.
39