Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for ALGE-Timing D-LCC
Summary of Contents for ALGE-Timing D-LCC
- Page 1 Version-E200610 Manual...
- Page 2 Important Information General Before using your ALGE-TIMING device read the complete manual carefully. It is part of the device and contains important information about installation, safety and its intended use. This manual cannot cover all conceivable applications. For further information or in case of problems that are mentioned not at all or not sufficiently detailed, please contact your ALGE-TIMING representative.
- Page 3 D-LCC Lap Counter Declaration of Conformity We declare that the following products comply with the requirements of the listed standards. Parts that we use in the product are CE certificated by the manufacturers and ALGE-TIMING GmbH does not change them. ALGE-TIMING GmbH...
-
Page 4: Table Of Contents
Manual D-LCC Lap Counter Table of Contents General .......................... 5 System Components: ..................... 5 Power Supply ......................... 5 Default Setting ........................ 5 Parameter Setting ......................6 Brightness ....................... 6 5.1.1 Setting the First Digit ..................6 5.1.2 Setting the Second Digit ................... 6 Countdown or Count-Up ................. -
Page 5: General
Manual D-LCC Lap Counter 1 General The display board D-LCC is a lap counter with very flexible functions. Laps can be counted up or down. Various models of the lap counter are available: • one-sided, double-sided, triple-sided • 1 digit per side, 2 digits per side, 3 digits per side •... -
Page 6: Parameter Setting
Manual D-LCC Lap Counter 5 Parameter Setting There is a menu for setting the parameters of the lap counter: brightness • • countdown or count-up • countdown start value hundreds Countdown start value till 99 • • format parameter •... -
Page 7: Countdown Or Count-Up
Manual D-LCC Lap Counter Countdown or Count-Up The factory setting is „Countdown“ starting with a value of 25. If you want to count up, you have to adjust the counting direction in the menu. The start value is always 0 (zero) for the count-up. -
Page 8: Transfer Speed/Protocol
(300 seconds = 5 minutes) Address Setting To use more than one D-LCC on an addressed protocol, you have to define the addresses of every single lap counter. Normally, the first line is address 1 , second line address 2 , etc. -
Page 9: Lap Counter Controlled By Timy
Manual D-LCC Lap Counter 7 Lap Counter Controlled by Timy It is possible to control the lap counter from the Timy. In order to do so, select the program “Commander” and then “Counter”. Now you can set any number desired and confirm with OK. -
Page 10: Technical Data
Manual D-LCC Lap Counter 9 Technical Data All connections, switches and status LEDs are on the bottom of the lap counter D-LC. Amphenol plug to connect controller D-CKA2-LCC RS232 connection status LED green – full battery status LED yellow – battery charging status LED red –... - Page 11 Manual D-LCC Lap Counter -11-...
- Page 12 Manual D-LCC Lap Counter Subject to changes Copyright by ALGE-TIMING GmbH Rotkreuzstr. 39 6890 Lustenau / Austria www.alge-timing.com -12-...
Need help?
Do you have a question about the D-LCC and is the answer not in the manual?
Questions and answers