Locale Settings And Confirmation; Creating The Locale Settings And Confirmation File; Locale Confirmation; Locale Setting Change - Polk Mono Signa S4 Service Manual

4. Locale settings and confirmation

4.1. Creating the locale settings and confirmation file

(1) Click [Start button] - [Accessories] - [notepad] on the PC to launch the notepad.
(2) Enter "TEXT".
(3) Click "File", and then click "Save As...".
(4) Enter the file name "atmos-config-locale-XXX" and click the Save button.
NOTE : Enter the file name in double quotation marks. (The file extension is not required.)
Locale File name
Confirmation

Locale Confirmation

"atmos-config-locale-get"
North America "atmos-config-locale-set-1"
Europe "atmos-config-locale-set-2"
Change
Japan "atmos-config-locale-set-3"
China "atmos-config-locale-set-6"
atmos-config-locale-XXXXX
(5) Copy the files created on the USB flash drive.
atmos-config-locale-get
atmos-config-locale-set-1
atmos-config-locale-set-2
atmos-config-locale-set-3
atmos-config-locale-set-6
4.2. Locale confirmation
(1) Insert the power cord plug and turn on the power.
• Do not connect anything to the unit.
(2) After the unit finishes starting up, insert the USB flash drive. (atmos-config-locale-get)
(3) Status LED1 blinks to indicate the locale.
North America(Green)
Europe(Blue)
Japan(Red)
China(Amber)
(4) Remove the USB flash drive device.
(5) After a reboot of this unit is completed, unplug the power cord.

4.3. Locale setting change

(1) Insert the power cord plug and turn on the power.
• Do not connect anything to the unit.
(2) After the unit finishes starting up, insert the USB flash drive. (atmos-config-locale-set-X)
• X : 1=North America, 2=Europe, 3=Japan, 6=China
(3) The status LED1 lights up in white for approximately 5 seconds.
• This indicates that the locale settings are complete.
Status LED1 blinks to indicate the locale.
North America(Green)
Europe(Blue)
Japan(Red)
China(Amber)
(5) Remove the USB flash drive device.
(6) After the unit finishes restarting, perform a factory reset.
•
(7) Remove the AC power cord.
copy to USB flash drive
48
Locale LED1
Blinking x 3(Green) -> Off(2sec)
Blinking x 3(Blue) -> Off(2sec)
Blinking x 3(Red) -> Off(2sec)
Blinking x 3(Amber) -> Off(2sec)
Locale LED1
Blinking(white) 5sec -> Blinking x 3 (Green)
Blinking(white) 5sec -> Blinking x 3 (Blue)
Blinking(white) 5sec -> Blinking x 3 (Red)
Blinking(white) 5sec -> Blinking x 3 (Amber)
See"3. Initialization Mode"