Restricted Preset Dispense Mode; Removing And Replacing The Battery; Quick-Lock ™ Nozzle - Graco Matrix D Series Instruction Manual

F . 18
IG
6. If the operator wants to top-off fluids, press the left
arrow key to display the TOP-OFF MODE. See F
19.
F . 19
IG
7. Pull the trigger to dispense the desired fluid amount
for top-off.
8. Press END to complete the job. See F
logs the dispense to the PC and returns the meter to
its programmed entry screen.
If END is not pressed, after 5 minutes the meter will
time out and log the dispense to the PC.
Restricted Preset Dispense
Mode
When meters are programmed in restricted preset
mode, the specified dispense value cannot be
increased, only decreased. The functionality of this fea-
ture is identical to Preset Dispense Mode (see Preset
Dispense Mode beginning on page 14) except that the
preset value can only decreased with the down keypad
button.
309497K
Removing and Replacing the
Battery
1. Remove the battery by pressing in on both battery
lock buttons (E) and pulling the battery (F) out and
away from the meter. See F
2. Place the battery in the battery charger. See
Instruction Manual 309502 for details.
3. Replace the battery by pressing in on both battery
lock buttons (E) and pushing the battery (F) into the
meter.
.
IG
If the meter displays a low battery warning, wait 30
seconds before installing a new battery. See Bat-
tery Life Indicator page 10.
.
. 19. This
IG
F . 20
IG
Quick-Lock
The nozzle opens and closes with LESS THAN
one turn.
1. To close the nozzle to prevent dripping, rotate left
(counter clockwise) until tight. See F
2. To open the nozzle for dispensing, rotate right
(clockwise) until fully open.
F . 21
IG
Meter Operation
. 20.
IG
E
F
™
Nozzle
. 21.
IG
Open
Close
ti64318
ti64319
15