Ice And Water Dispenser - GE Profile PSSF3RGZ Owner's Manual And Installation

About the ice and water dispenser.
Spill Shelf
To Use the Dispenser
Select CUBED ICE
, CRUSHED ICE
or WATER
.
Press the glass gently against the top of
the dispenser cradle.
The spill shelf is not self-draining.
To reduce water spotting, the shelf and
its grille should be cleaned regularly.
If no water is dispensed when the refrigerator is
first installed, there may be air in the water line
system. Press the dispenser arm for at least two
minutes to remove trapped air from the water
line and to fill the water system. To flush out
impurities in the water line, throw away the first
six glassfuls of water.
CAUTION: Never put fingers or any other
objects into the ice crusher discharge opening.
Locking the Dispenser
Press the LOCK CONTROL
pad for 3 seconds to lock
the dispenser and control
panel. To unlock, press
and
hold the pad again
for 3 seconds.
Important Facts About Your Dispenser
Do not add ice from trays or bags to
the storage drawer. It may not crush or
dispense well.
Avoid overfilling glass with ice and use
of narrow glasses. Backed-up ice can jam the
chute or cause the door in the chute to freeze
shut. If ice is blocking the chute, poke it
through with a wooden spoon.
Beverages and foods should not be
quick-chilled in the ice storage drawer.
Cans, bottles or food packages in the storage
drawer may cause the icemaker
or auger to jam.
To keep dispensed ice from missing
the glass, put the glass close to, but not
touching, the dispenser opening.
(on some models)
Dispenser Light
Quick Ice
Door Alarm
Some crushed ice may be dispensed
even though you selected CUBED ICE. This
happens occasionally when a few cubes
accidentally get directed to
the crusher.
After crushed ice is dispensed, some water
may drip from the chute.
Sometimes a small mound of snow will form
on the door in the ice chute. This condition
is normal and usually occurs when you have
dispensed crushed ice repeatedly. The snow
will eventually evaporate.
GEAppliances.com
This pad turns the night
light in the dispenser
on and off. The light also
comes on when
the dispenser cradle is
pressed. On some models,
if this light burns out, it
should be replaced with a
6 watt 12V maximum
bulb.
When you need ice
in a hurry, press this
pad to speed up ice
production. This will
increase ice production for
the following
48 hours or until you
press the pad again.
To set the alarm, press this
pad until the indicator
light comes on. This
alarm will sound if either
door is open for more
than
3 minutes. The light goes
out and the beeping stops
when
you close the door.
15