Assembling Your Vacuum - Shark Navigator NV105 Series Instructions Manual

ASSEMBLING YOUR VACUUM

NOTE: Not all accessories are available
on all models.
IMPORTANT: For suction to reach the
power nozzle, the extension wand and
stretch hose must be attached securely
to the vacuum body.
NOTE: When lifting or carrying, DO
NOT press Dust Cup Release button
( ).
NOTE: Once the hose connector has
been inserted, it cannot be removed.
NOTE: The accessory holder is
removable. In order to remove or
attach the accessory holder, you must
remove the dust cup first. To remove
the accessory holder, just hold the tab,
rotate counterclockwise and pull out.
To replace, align the pins with the
hinges on the vacuum. Rotate the
holder clockwise to secure.
7
s h a r kc l e a n . c o m
YOUR SHARK NAVIGATOR IS EASY TO
®
ASSEMBLE:
1
Stand vacuum body upright on a
level surface.
2
Insert the hose connector into
the opening on the back of the
vacuum body.
3
Insert the handle with the extension
wand into the top of the vacuum
until secure.
4
Insert the stretch hose into the
hose connector on the back of the
vacuum body, pressing it in until it
clicks into place.
5 Store your onboard tools on the
accessory holder located on the back
of the unit.
6
When storing your vacuum, wind
the power cord around the two cord
holders and secure with cord clip.
7
There is a Quick Cord Release on the
top cord holder. Simply turn the cord
holder to the left or right to release
the power cord. To store the unit,
the cord holder should be in the
upright position.
8 TO CARRY THE VACUUM: With
the unit in the standing position,
lift by the carry handle on top of
the dust cup.
Hose Connector
8
s h a r kc l e a n . c o m