Advertisement
C Tie to Boom—Large Diameter Object
C1 Pass line through
mouth, through head
and around boom so line
crosses as shown.
C2 Repeat C1.
Cross lines.
C3 Repeat C1.
Cross lines.
See: E Finish—Dead-End Line.
C4 If you have access to
end of boom, make three
loops as shown.
Cross each loop
separately as shown.
C5 Slide crossed lines
onto end of boom.
See: E Finish—Dead-End Line.
C6 IMPORTANT!
You must use crossed
lines when tying to a
C1
large diameter so
head of block is
not damaged.
C7 Once tied, block can be rotated to either a parallel or
perpendicular position (C8).
C7
C2
C3
D Add Becket
D1 Pass line through
mouth to make two
becket loops.
C4
D2 Follow instructions
A, B, C or D to attach
to bail, post or boom.
C5
See: E Finish—Dead-End
Line.
C6
INCORRECT
C8
E1 Start with line
coming out of mouth,
pass it through small
dead-end hole. On
2607 (57mm) pass
line though outer hole
at side of rivet then
through inner hole.
D1
MOUTh
D2
Harken
equipment is designed for minimal maintenance, but some
®
maintenance is required for optimum and safest possible operation
and to comply with the Harken limited warranty.
In general, the most important aspect of maintenance is to keep
your equipment clean by frequently flushing with fresh water.
For additional safety, maintenance and warranty information see
www.harken.com or the Harken
E Finish—Dead-End Line
E1 Cinch block to
E1
desired tension.
E3 Tie a loose figure
E3
eight knot. Move knot
so it is tight against
block. Leave at least
25mm (1") of line
beyond knot. Repeat
for other line end.
Trim excess line.
Maintenance
Warranty
catalog.
®
Printed in USA 4927/10-08
E2
Advertisement
