Table of Contents
Advertisement
display and the given information
changes accordingly.
If a selection is not possible
an acoustic signal sounds
and the display shows
.
10.6 Starting a programme
Touch the Старт/Пауза
start the programme. It is not possible to
start the programme when the indicator
of the button is off and doesn't flash (e.g.
programme dial on a wrong position).
The related indicator stops flashing and
stays on.
The programme starts, the door is
locked. The display shows the indicator
.
The drain pump can operate
shortly before the appliance
fills water.
10.7 Starting a programme with
the delay start
1. Touch the Отсрочка старта button
repeatedly until the display shows the
desired delay time. On the display the
indicator shows
2. Touch the Старт/Пауза
The appliance door locks and starts the
countdown of the delay start. The display
shows the indicator
When the countdown is completed, the
programme starts automatically.
Cancelling the delay start after
the countdown has started
To cancel the delay start:
1. Touch the Старт/Пауза
pause the appliance. The related
indicator flashes.
2. Touch the Отсрочка старта button
repeatedly until the display shows
and the indicator
3. Touch the Старт/Пауза
again to start the programme
immediately.
button to
.
button.
.
button to
goes off.
button
Changing the delay start after
the countdown has started
To change the delay start:
1. Touch the Старт/Пауза
pause the appliance. The related
indicator flashes.
2. Touch the Отсрочка старта button
repeatedly until the display shows the
desired delay time.
3. Touch the Старт/Пауза
again to start the new countdown.
10.8 The SensiCare System
load detection
The programme duration in
the display is referred to a
medium/high load.
After touching the Старт/Пауза
button, the maximum declared load
indicator goes off, the SensiCare System
starts the laundry load detection:
1. The appliance detects the load in the
first 30 seconds. In the programmes
where Менеджер времени is
available, during this phase the
Менеджер времени bars
placed below the time digits play a
simple animation. The drum rotates
shortly.
2. The programme duration could be
adjusted accordingly and could
increase or decrease. After further 30
seconds, the water filling starts.
At the end of the load detection, in case
of drum overload, the indicator
flashing in the display:
In this case, for 30 seconds, it is possible
to pause the appliance and remove the
exceeding garments.
Once removed the exceeding garments,
touch the Старт/Пауза
start the programme again. The
SensiCare phase can be repeated up to
three times (see point 1).
Important! If the laundry amount will not
be reduced, the washing programme
ENGLISH
29
button to
button
is
button to
Advertisement
Table of Contents
