Table of Contents
Advertisement
2.4.2
Memory Installation
AIIS-5410P system has 4GB memory on board; if you want to add more memory,
please connect your distributor or sales representative to order compatible memory
modules. Part numbers below:
4G SO-DDR4-2133 512X8 1.2V SAM
8G SO-DDR4-2133 512X8 1.2V SAM
16GB DDR4 2133 1.2V SODIMM 1GbX8 SAM
Note!
If non-compliant SODIMM memory boards are installed in the AIIS-
5410P, the system will not boot.
1.
Undo 6 screws and remove the bottom cover.
1.
Undo 4 screws to remove HDD tray.
2
2.
Undo 3 screws to remove the memory thermal cover.
3.
Affix thermal pad on memory, and reassemble memory.
Note!
Thermal pad and memory thermal cover must be completely covered
and secured.
2.4.3
m-SATA/Mini-PCIe Installation
AIIS-5410P provides one Mini-PCIe socket that supports both Mini-PCIe signal and
m-SATA.
(Please refer to MB internal I/O connector specification on the I/O connector page.)
1.
Undo 6 screws and remove the bottom cover.
2.
Install the module in the Mini-PCIe socket and secure with screws.
3.
Replace bottom cover and secure with screws.
2
2
3
19
P/N: AQD-SD4U4GN21-SG
P/N: AQD-SD4U8GN21-SG
P/N: AQD-SD4U16N21-SE
AIIS-5410P User Manual
Advertisement
Table of Contents
