Table of Contents
Advertisement
INSTRUCTIONS
BATTERY REMOVAL AND INSTALLATION
Make sure the unit is turned OFF.
1.
2.
Locate the battery cover on the bottom of
the unit. Use a screwdriver to loosen the
screw.
3.
If used batteries are present, remove these
batteries from the unit by pulling up on one
end of each battery.
4.
Install 1 new AAA (AM-4/LR03) battery
following the diagram inside the battery
box. (The use of new alkaline batteries is
recommended for maximum performance.)
5.
Replace the battery cover and tighten
the screw to secure.
WARNING: Adult assembly required for battery installation. Keep batteries out of
reach of children.
Removing the packaging locks
Rotate the packaging lock anticlockwise
several times.
Pull out the packaging lock and discard.
3
3
3
Advertisement
Table of Contents
Need help?
Do you have a question about the Wind & Go Turtle and is the answer not in the manual?
Questions and answers