Turning You Atv - LONCIN LX200AU-2 Manual

Turning you ATV

To achieve maximum traction while riding off- Road,
the two rear wheels are mounted solidly on one
axle and turn together at the same speed.
Therefore, unless the wheel on the inside of the
turn is allowed to slip or lose some traction, the
ATV will resist turning. A special turning technique
must be used to allow the ATV to make turns
quickly and easily. It is essential that this skill be
learned first at low speed.
As you approach a curve, slow down and begin to
turn the handlebars in the desired direction. As you
do so, put your weight on the footboard to the out-
side of the turn (opposite your desired direction)
and lean your upper body into the turn. Use the
throttle to maintain an even speed through the turn.
This maneuver will let the wheel on the inside of
the turn slip slightly, allowing the ATV to make the
turn properly.
This procedure should be practiced at slow speed
many times in a large off-road area with no
obstacles. If an incorrect technique is used, your
ATV may continue to go straight. If the ATV doesn't
turn, come to a stop and then practice the proce-
dure again. If the riding surface is slippery or loose,
it may help to position more of your weight over
the front wheels by moving forward on the seat.
Once you have learned this technique, you
should be able to perform it at higher speeds
or in tighter curves.
7-8