Page 3
Congratulations! You are about to install and use a device from the Stromtank range. You have chosen a high-tech device that will play a central role to hear the excellent quality of your audio components. Stromtank has been...
Page 4
Stromtank must comply with the applicable laws and regulations. The weight of Stromtank S1000 is 41 kg / 90 Ibs. Use an appropriate lifting method as well as help from a second party when installing the equipment.
While the Stromtank is still in its case, please move it to a location near the place where it will be installed. Remove all jewelry including watches, rings and belts from your person to avoid damage to the exterior of the Stromtank during removal and installation.
REAR PANEL – Hubbel duplex thermal magnetic fuse power indicator service port converter AC input service port BMS main switch ON / OFF emergency charge input (for service lock / unlock for transport safety purpose only, contact your dealer) ground terminal AC outlets fuse (10A - 230V/16A-120V slow blowing) REAR PANEL –...
Before you start with the installation take care that no audio parts are connected with the Stromtank and the unit is not connected with the electric circuit. To install the Stromtank and connect it with your audio equipment please follow the steps in order.
DISPLAY OPERATION The LED bargraph at the front of Stromtank indicates the state of charging in 10 steps from 10 % up to 100 %. When all 10 indicators are illuminated the unit is fully charged (100 %). If only one indicator is shown the unit is nearly empty (state of charging: 10 %).
Before it will be switched off there will be an acoustic alarm signal for approx. 1 minute. If the red LED at the front is lighting check if Stromtank is connected by AC-in power cord to the electric circuit. When the red lighting of the LED at the front disappears the charging mode started (front meter shows charge current).
Do not rub or polish the finish and do not allow objects to come in contact with it. To clean the Stromtank first unplug the unit from the electric circuit. To wipe off fin- gerprints and other grease spots spray a small amount of mild detergent dissolved in water onto the supplied microfiber cloth and gently wipe the surface with the close.
– magnetic circuit breaker AC input connection ICE 320 - C14 (fuse 10AT / 16 AT*) Interface converter, BMS*, emergency charger in case of undervoltage* * only for use with Stromtank software and charger Design and specifications are subject to change without notice.
The manufacture, assem- bly and tests for each Stromtank are carried out in their entirety by its factory in Germany. The warranty for this equipment depends upon the strict application of the instructions appearing in this manual.
Page 19
Stromtank will pay for return shipping. 7. This warranty covers only defects in products made by Stromtank. It does not cover incidental or consequential damages, or damages to other products resul- ting from defects in Stromtank products.
Need help?
Do you have a question about the S1000 and is the answer not in the manual?
Questions and answers