LM Technologies LM400 At Command Manual page 11

2.8.11.2 AT+MODEM?<cr>
2.8.11.2.1 Response
<cr,lf>MODEMc<command_response> if the command is successful. Here, c- current
modem signal setting. E.g on default setup, the response will be <cr,lf>MODEM-
<command_response>
2.8.11.3 Modem Signal Meaning
The modem signal setting is used in conjunction with AT+FLOW Settings to enable/disable
RS232 modem control signals as per the table below.
FLOW
CONTROL
(AT+FLOW)
FLOW-
FLOW+
FLOW-
FLOW+
FLOW-
FLOW+
©2013 LM Technologies Ltd
AT Command Manual
MODEM RS232 SIGNALS
SIGNAL USED
(AT+MODEM)
MODEM- Tx, Rx, GND
MODEM- Tx, Rx, GND, RTS,
CTS
MODEML Tx, Rx, GND, RTS<-
>CTS, DTR<->DSR
MODEML Tx, Rx, GND, RTS,
CTS, DTR<->DSR
MODEMR Tx, Rx, GND, RTS(R),
CTS(R), DTR(R),
DSR(R)
MODEMR Tx, Rx, GND, RTS,
CTS, DTR(R), DSR(R)
www.lm-technologies.com
Description
3 wire configuration.
RTS/CTS signals are used for data
flow control between host and
local Bluetooth device, and NOT
transferred to remote Bluetooth
device wirelessly.
RTS looped back to CTS, DTR
looped back to DSR. No RS232
control signal transferred to
remote Bluetooth device
wirelessly.
RTS/CTS signals used for data
flow control between host and
local Bluetooth device, and NOT
transferred to remote Bluetooth
device wirelessly. DTR looped
back to DSR. This configuration is
equivalent to LM048 adapter
running v4.5x firmware.
All 7 signals used. All RS232
control signals (DTR, DSR, RTS
and CTS) transferred wirelessly to
remote Bluetooth device.
All 7 lines used. Only DTR, DSR
signals transferred wirelessly to
remote Bluetooth device. If RTS,
CTS signals are not used, then
this configuration is equivalent
to LM048SPA Adapter running
v4.6X firmware.
Page 11 of 26
v1.5