Machine Installation Requirements - Yamaha S20 Service Information

1. Machine installation requirements

Confirm the following machine installation requirements and install the machine where
the following conditions are satisfied.

Air
Item
Air pressure Supply air pressure: 0.45MPa or more
・
50L / min.A.N.R. (4-head type)
・
Condition 75L / min.A.N.R. (6-head type)
・ 140L / min.A.N.R. (12-head type)

Power supply
Item
Three-phase alternating current 200 / 208 / 220 /
Power supply
240 / 380 / 400 / 416 / 440V (+/-10%)
Frequency 50Hz / 60Hz
S10：6.4 KVA S20：6.8 KVA
Power capacity
M10：5.5 KVA M20：5.9 KVA D10： 5.5 KVA
D10 =5.5KVA
Power supply
Power cable conductor cross-section 3.5mm
connection
more
Leakage current 20mA or less

Installation environment requirement
Item
Noise Meeting EN61000-6-2 standard
Humidity 50 ~ 60% (non-condensing)
Operation assurance: Within the range from 10 to 35 degrees C
Temperature
Accuracy assurance : 23+/-2 degrees C
Altitude 1,000m or below above sea level
The floor must be flat and has the enough strength of enduring
Floor
the vibration of the machine during the operation.
Note:
If the machine that is the source of noise locates in the line configuration, do not share
the power supply and the ground wire.
Connect the power supply to the separate lineage from the power distribution panel.
Install the ground wire individually.
Note:
If the strong light from the indoor lightings, the direct sunlight and etc., may enter the machine
due to the machine configuration, note that the lights may adversely affect to the image processing.
Detail
Detail
2
Detail
SI1604009E-002= S20, S10, M20, M10 and D10 installation procedures
3/34
For Service Engineer
Service Information
Remark
 
8.5mm × 12.5mm hose
Clean air (Removed moisture, oil and dust)
Remark
Power cable (equivalent to VCT 4 × 3.5mm
or
The average over a period of 24
hours does not exceed 30 degrees C
2
)
Remark