Place A Jack - Yamaha S20 Service Information

3.7.4

Place a jack

Figures of a jack placed under the each machine
Position A
*S20 and M20: Set a jack at the left, right, front and rear of [position A].
*S10, M10 and D10: The cover of the right side of the machine is protruding and a normal jack cannot be
inserted into the machine.
*When setting a hydraulic toe jack from the outer cover side of the machine at the [position B],
the cover is longer than the frame downward. And when setting a wood plate between a jack and the
machine frame, make sure that the wood plate will not interfere with the cover.
[S10 / M10 / D10]
Right side cover seen from the front of the machine.
If there is no position to insert
a jack, use a mini jack.
Front of a jack setting position
The stroke of the mini jack is 60mm only. Use a wood plate or an aluminum plate for the height raising.
Service Information
Position B
SI1604009E-002= S20, S10, M20, M10 and D10 installation procedures
16/34
For Service Engineer
[S10 /M10 / D10] Under the base
Rear of a jack setting position