Table of Contents
Advertisement
For gas hot-air heaters MONZUN is designed MMC regulation, which allows manual and automatic
control of MONZUN heaters. Programmable thermostat with LCD touch screen and DS18B20 internal
temperature sensor with the possibility of external sensor connection. Installation box on the wall
(protection class IP 30) with added deblocking button RESET. Manual and continuous automatic
regulation of burner output in heating mode, with the possibility to set a weekly heating program. The
control box is an optional accessory and if it is not connected, the heater will switch to minimum output
power when switched on by the service switch.
Regulation MMC
wago
FU
L
Vent
Valve
N
B
R
Y
+
-
R1
R2
GND 0/10V
The device is preset by the manufacturer, its operation depends on correct installation and adjustment.
All equipment is tested for safety and serviceability when finished.
MONZUN heaters are packed in cardboard boxes on special pallets. The package allows you to store
up to three heaters on top of each other.
They are transported with covered vehicles. During transport, heaters must be protected against
mechanical damage and weathering. There must be no vibration and the ambient temperature must not
exceed +50 °C.
The heaters must be stored in covered buildings, in an environment free from aggressive vapours,
gases and dust. Temperatures in the range -5 to +40 °C and relative humidity max. 80% must be
maintained in the buildings. During handling and storage, the heaters must be protected against
mechanical damage.
Gas hot-air heater MONZUN
CYSY 5Cx0,75
L1
PE
R1
R2
JYTY-O 4x1
(SYKFY 2x2x0,5)
DC
PE
CYKY 3x1,5
PE N
L
230 V / 50 Hz
18
XS
VENTILATION
C
C
DEVICE IN HEATING MODE
O
O
ALARM
A
A
HEATING
H
H
OVERHEAT
E
E
L1
N
N
PE
XR
RESET
R1
RESET
R2
XM
MODULATION 0/10 V
+
+
-
-
GND
+24 V
DC
XP
PE
N
N
L
L
Advertisement
Table of Contents
