Electrical Installation - Mandik MONZUN 15 Series Installation, Operation Instructions And Maintenance Manual

The heater must only be connected by an authorized organization. Before connecting, check that the
type and pressure of the gas correspond to the data on the data label (on the rear panel of the heater).
The gas hose is subject to regular inspections and inspections as gas distribution (TPG 704 01). Hoses
must be protected against mechanical stress and aggressive substances. The hose must not be
subjected to tension.
The MONZUN heaters are connected to the terminal block by a power supply with a stop switch / circuit
breaker. The power input is decisive for supply sizing.
The MONZUN heaters must be connected to the TN-S system in accordance with the applicable
standards. The power supply must have the required protection according to the relevant standard.
According to EN 61140, MONZUN heaters are class I electrical appliances and are equipped with a
protective conductor connection terminal. This terminal must be connected acc. to the above standard.
3800 4600 4500
3500 3500 4150
2750 2750 3500
5,8 5,8 5,5
3900 4700 4600
3500 3500 4150
2750 2750 3500
5,5 5,5 5,5
3700 4700 4900
3500 3500 4100
2750 2 3400
6,0 6,0 6,0
11
5500 4500 52500
4150 4100 4100
3500 3800 3800
5,5 5,4 5,4
5600 4600 5250
4150 4100 4100
3500 3800 3800
5,5 5,4 5,4
5400 4700 5500
4100 4100 4100
3400 3300 3300
6,0 5,5 5,5