Table of Contents
Advertisement
3.1 - Installation of the fitted group
1 - Make a
rectangular
opening in the
base of the
overhead
cupboard or
hood, leaving a
minimum of 13 mm from the
outer edges according to the
dimensions indicated in the
table.
2 - Drill a hole into the upper side
of the cabinet in accordance
with the dimensions of the
duct used for both the
evacuation and recirculation
mode.
3 - Dismantle the ducting support
(version with grill or version
with filters), pulling the two
pommels A (fig. 1)
simultaneously:
a) Fixing frame with screws:
Fix the fitted group to the hood
or cupboard, using the self-
threading screws (No. 10)
provided
with the
accessories (fig. 2).
b) Rapid fixing with side
supports:
The device B is set up
to deal with a panel
thickness of from 15
mm to 30 mm. Insert
the group into the
opening until the two
devices B connect. Lock
the adjustment screw C
until the fitted group adheres
tightly to the surface (fig. 2).
Part 1 - INSTALLATION INSTRUCTIONS
2
1
5
Advertisement
Table of Contents
