Part 1 - INSTALLATION INSTRUCTIONS 1 - GENERAL INFORMATION This canopy hood is designed to be fitted into cabinets or chimney cooker hoods, placed above a hotplate. It can be used either in the extraction mode (ducted to the outside) or in the recirculation mode (internal recycling). Before starting the installation, consideration should be given to the difficulties to be found during installation.
Part 1 - INSTALLATION INSTRUCTIONS 3.1 - Installation of the fitted group 1 - Make a rectangular opening in the base of the overhead cupboard or hood, leaving a minimum of 13 mm from the outer edges according to the dimensions indicated in the table.
Part 1 - INSTALLATION INSTRUCTIONS 4 - Close the ducting support by pushing and connecting the two pommels A (fig. 3). 3.2 - Ducting or recirculation fitting 1 - Ducting fitting: a) The hood can be ducted to the outside using either a rigid or a flexible Ø...
Part 2 - USE AND MAINTENANCE INSTRUCTIONS 1 - SAFETY WARNINGS It is most important that all the warnings shown in paragraph 2 of the Installation Instructions are strictly observed. Moreover, special attention must be paid to the following warnings during the use and maintenance of the cooker hood: 1.1 - The grease filters and the charcoal filters should be cleaned or replaced as recommended by the manufacturer or more frequently if the hood is used consistently (more than 4 hours per day).
Part 2 - USE AND MAINTENANCE INSTRUCTIONS 3.1 - Synthetic filters 1 - This filter cannot be washed and should be replaced every two months. If the filter is provid ed with a saturation indicator, replace when the violet color of the dots which are visible from the outside is spread over the whole surface of the filter.
Part 2 - USE AND MAINTENANCE INSTRUCTIONS 3.4 - Cleaning When cleaning the hood: - Never use a wet cloth or sponge, or running water. - Never use thinners or products containing alcohol, as they might damage the paintwork. - Never use abrasive cleaning materials, in particular when cleaning stainless steel surfaces.
Page 10
SERVICE AND SPARE PARTS In the event of your appliance requiring service, or if you wish to purchase spare parts, please contact your local Service Force Centre by telephoning:- 08705 929929 Your telephone call will be automatically routed to the Service Force Centre covering your post code area.
Page 11
Standard guarantee conditions We, EHP, undertake that if within 12 months of the date of purchase this Firenzi appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labour, materials or carriage on condition that: The appliance has been correctly installed and used only on the electricity supply stated on the rating plate.
Page 12
This appliance conforms to European Low Voltage Directive 73/23/CEE governing electrical safety, European Directive 89/ 336/CEE on Electromagnetic Compatibility and Directive 93/68/CEE regarding CE Marking. 436001866_01 - 030924...