Care And Cleaning; Burner Caps; Stainless Steel - GE Monogram ZGU364NDPSS Owner's Manual

Dual-flame The burner consists of three parts: the burner
base, burner head and burner cap. The burner
stacked
head and burner cap can be lifted off, making
burners
them easy to clean.
BURNER WITHOUT ALL BURNER PARTS IN PLACE.
Surface burners should be cleaned routinely,
especially after bad spillovers, which could clog
the slots and holes in the burner heads.
The electrode is located at the rear of each
burner. Do not attempt to disassemble or clean
around any burner while another burner is on. An
electric shock may result.
To remove the burner parts:
1. Turn all controls OFF before removing any
2. When cool, you may lift off the burner grates,
Do not use a steel-wool pad; it will permanently
Stainless
scratch the surface.
steel
To clean the stainless steel surface, use
surfaces
warm sudsy water or a stainless steel cleaner.
Always wipe the surface in the direction of the
grain. Follow the cleaner instructions for cleaning
the stainless steel surface.
14
CAUTION:
DO NOT OPERATE THE
Electrode
burner parts.
burner caps and burner heads for easier
cleaning. Do not remove the burner bases.

Care and Cleaning

Cleaning
Lift off burner parts only when cool. Wash in hot,
soapy water. You may use a plastic scouring pad
to remove burned-on food particles.
To remove burned-on food, soak the burner
heads in a solution of mild liquid detergent and
hot water for 20–30 minutes. For more stubborn
stains, use a plastic scouring pad or toothbrush.
If the spill goes inside the burner head assembly,
wash it under running water and shake to
remove excess water.
After Cleaning
Before replacing the burner parts, shake out
excess water and then dry them thoroughly.
To replace the burner parts:
Burner Cap
Make sure that the burner parts are replaced in
the correct location.
1. Replace the burner head on top of the burner
Burner Head
2. Place the burner cap on top of the burner
Burner Base
A bottle of stainless steel cleaner is provided with
the rangetop.
To inquire about purchasing stainless steel
appliance cleaner, please call our toll-free
number, 800.626.2002 or visit monogram.com.
Professional Rangetops
base, making sure that the hole in the burner
head is properly aligned with the electrode in
the burner base. A small gap between the
base and head is normal.
head. Make sure that the burner cap is
properly seated on the burner head.
Burner cap properly seated
Burner cap not properly seated