Table of Contents
Advertisement
GETTING STARTED
Before First Use:
When new, this device will have some plastic smell. To reduce the smell, it is
recommended to run the device for about 5-8 minutes (or until the plastic smell fades)
prior to first use.
Use only on a flat, level surface.
•
Place the device on a flat, level and solid surface, such as a desk, table or bench.
•
Do not hold the appliance in your hands during use.
Removing the water supply tank
•
Pull up on the water tank to remove it from the device.
•
Open the water supply cap by turning.
•
Fill the water tank with distilled or purified only and close the water supply cap.
•
Slide the water tank back into the opening on the device.
•
Wipe away any water on the surface of the water supply tank.
Note: Ensure the power is switched off when adding water
Powering on
1.
Connect the plug to a power outlet.
2.
Rotate the Mode Selector switch to turn on the appliance and set to your intended
use (Warm Towel, Facial Steamer or Humidifier).
Refer to the following pages for each mode's usage instructions.
.
Advertisement
Table of Contents
