Table of Contents
Advertisement
ASSEMBLY & OPERATION
Installing Multiple Position Handle
1) The handle (A) Fig.5 gets mounted on the left or right
side of the gear housing, alternatively it can also be
mounted on the top of the tool. Choose the position
that provides the most comfortable and safest
handling.
Installing Grinding Wheel
• DISCONNECT BATTERY FROM TOOL BASE.
1) Press and hold down the spindle lock button (B) Fig.5.
2) Remove the outer flange (A) Fig.6 with the included
spanner wrench (B) by turning counterclockwise. The
spanner wrench is located inside the the multiple
position handle.
3) Install grinding wheel (C) Fig.6 against the inner flange
(D).
4) Secure new grinding wheel with outer flange (A) by
pressing and holding spindle lock button and using
spanner key (B) Fig.6 (clockwise).
5) If the safety guard (E) Fig.6 is not in the most suitable
position for the operation, it is recommended to shift
the position of the safety guard by releasing the clamp
(F), shift safety guard position and secure safety guard
with the clamp.
Warning! If you wish to install a wire brush, the safety guard must be removed. Reinstall
safety guard once the wire brush operation is finished.
Warning! Before removing a grinding wheel after any operation, let the wheel cool down
before attempting to remove it and touching it with your fingers, risk of burning!
OPERATION
1) Use the side handle to help steady the tool and assist movement.
2) Different grinding angles produce different finishes. For rough stock, grind at a 30º
angle. For finishing operations, grind at a 15º angle.
3) Do not use excessive force, let the grinding wheel do most of the work.
4) Once the grinding operation is finished, release the trigger backward to stop the grinder,
wait until the grinding wheel has come to a complete stop before you put the tool down.
OPERATION
Figure 5
Figure 6
Advertisement
Table of Contents
