Operation - King Canada CONNECT 1 8035LK-BC Instruction Manual

USING YOUR 20V MAX LITHIUM-ION CORDLESS
4-1/2" ANGLE GRINDER
WARNING: Do not install battery until the accessory is
installed securely to the tool. Wear protective gloves
and safety glasses, an accessory can become extremely
hot during operation, danger of burns!
Charging the battery/battery level indicator
20V max Li-ion batteries come with a battery power level
indicator (A) Fig.2, press the button (B) to see the charge
level. If the battery level is low charge the battery. To
charge the battery (C) Fig.2, plug charger (D) power cord
into a 120V AC receptacle (do not use extension cord).
The red LED (F) will light up to indicate power to the
charger. Align the grooves the battery with those of the
charger and slide the battery all the way until it snaps into
place. The green LED (E) will flash indicating the
charging procedure has begun. Once the green LED (E)
stops flashing, the battery is fully charged and ready to
use. Press the battery clip (B) Fig.3 to remove battery
from charger.
Installing/removing battery from drill
To install a battery (A) Fig.3 to the base of the cordless
Angle Grinder, align the grooves of the battery with those
of the base and slide the battery all the way until the
battery clip (B) snaps and holds the battery into place.
To remove the battery from the base, press the battery
clip (B) Fig.3 and slide the battery away from the base.
Turning Tool On/Off
To turn your Angle Grinder ON, push the switch (A) Fig.4
towards the front of the tool. Release switch to turn your
Angle Grinder OFF.

OPERATION

Figure 2
Figure 3
Figure 4