Summary of Contents for King Canada CONNECT 1 8035LK-BC
- Page 1 20V MAX LITHIUM-ION CORDLESS 4-1/2 ANGLE GRINDER KIT MODEL: 8035LK-BC INSTRUCTION MANUAL COPYRIGHT © 2020 ALL RIGHTS RESERVED BY KING CANADA TOOLS INC.
-
Page 2: Warranty Information
Contact your retailer or visit our web site at www.kingcanada.com for an updated listing of our authorized service centers. In cooperation with our authorized service center, King Canada will either repair or replace the product if any part or parts covered under this warranty which examination proves to be defective in workmanship or material during the warranty period. - Page 3 GENERAL & SPECIFIC SAFETY INSTRUCTIONS 1. KNOW YOUR TOOL Read and understand the instruction manual and labels affixed to the tool. Learn its application and limitations as well as its specific potential hazards. 2. Don’t use power tools in damp or wet locations or expose them to rain. Keep work area well lit and provide adequate surrounding work space.
- Page 4 LITHIUM-ION BATTERY & CHARGER INFORMATION WARNING: The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator.
-
Page 5: Getting To Know Your Tool
Inspect the tool carefully to make sure no breakage or damage has occurred during transport. If any parts are missing, do not attempt to use the tool until you have obtained the missing parts from your King Canada retailer. Contents: 1- Cordless 4-1/2”... -
Page 6: Operation
OPERATION USING YOUR 20V MAX LITHIUM-ION CORDLESS 4-1/2” ANGLE GRINDER WARNING: Do not install battery until the accessory is installed securely to the tool. Wear protective gloves and safety glasses, an accessory can become extremely hot during operation, danger of burns! Charging the battery/battery level indicator 20V max Li-ion batteries come with a battery power level indicator (A) Fig.2, press the button (B) to see the charge... -
Page 7: Assembly And Operation
OPERATION ASSEMBLY & OPERATION Installing Multiple Position Handle 1) The handle (A) Fig.5 gets mounted on the left or right side of the gear housing, alternatively it can also be mounted on the top of the tool. Choose the position that provides the most comfortable and safest handling. -
Page 8: Maintenance
3. DON’T allow petroleum based products to come into contact with the plastic parts of the tool, as they contain chemicals that can damage or destroy the plastic parts. PARTS DIAGRAM & PARTS LISTS Refer to the Parts section of the King Canada web site for the most updated parts diagram and parts list.