Advertisement
Quick Links
I N S T R U C T I O N S
IN THE BOX
Make sure you have everything shown here.
This remote must be paired to and used
with a Security Brands Ridge 2.0 Transceiver
(Model 14-REC20) to work correctly.
WHAT'S WHAT
The Ridge Remote has two programmable buttons and
a status LED. Each button can be paired to a separate
transceiver or the same transceiver and set to different
modes of operation.
BASIC SETUP
1. On Ridge 2.0 Transceiver, hold down
PROGRAMMING PAIR button for three seconds
and release. PROG LED will light up.
NOTE: The transceiver must be powered up and
have its cover removed for this step. Please see the
instructions that came with it for help.
2. On Ridge Remote, press and hold down both
buttons and pay attention to remote LED.
RIDGE REMOTE (433 MHZ)
Button 1
Button 2
1 of 2
Ridge Remote
LED
PROGRAMMING PAIR
Button
PROG LED
Model 14-R433
Visor Clip
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Security Brands Ridge Remote
Summary of Contents for Security Brands Ridge Remote
- Page 1 Please see the PROGRAMMING PAIR instructions that came with it for help. Button PROG LED 2. On Ridge Remote, press and hold down both buttons and pay attention to remote LED. 1 of 2...
- Page 2 Step 3 Step 4 MODE SELECTION (MOMENTARY/LATCH) 1. On Ridge Remote, press and hold down both buttons and pay attention to remote LED. 2. When LED flashes twice, continue holding both buttons. 3. When LED flashes twice again, continue holding Go to securitybrandsinc.com/ridge/ for...
Need help?
Do you have a question about the Ridge Remote and is the answer not in the manual?
Questions and answers
Lost key need to change the battery-Security Brands Ridge 2.0 – 433-MHz Keypad and Transceiver – Post Mount | SEC-14-500