Advertisement
I N S T R U C T I O N S
IN THE BOX
Make sure you have everything shown here.
This remote must be paired to and used
with a Security Brands Ridge 2.0 Transceiver
(Model 14-REC20) to work correctly.
WHAT'S WHAT
The Ridge Remote has two programmable buttons and
a status LED. Each button can be paired to a separate
transceiver or the same transceiver and set to different
modes of operation.
BASIC SETUP
1. On Ridge 2.0 Transceiver, hold down
PROGRAMMING PAIR button for three seconds
and release. PROG LED will light up.
NOTE: The transceiver must be powered up and
have its cover removed for this step. Please see the
instructions that came with it for help.
2. On Ridge Remote, press and hold down both
buttons and pay attention to remote LED.
www.ShopAmericanAccess.com | (800) 878-7829 | Sales@ShopAmericanAccess.com
RIDGE REMOTE (433 MHZ)
Button 1
Button 2
Ridge Remote
LED
PROGRAMMING PAIR
Button
PROG LED
Model 14-R433
Visor Clip
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Security Brands 14-R433
Summary of Contents for Security Brands 14-R433
- Page 1 Model 14-R433 IN THE BOX Make sure you have everything shown here. This remote must be paired to and used with a Security Brands Ridge 2.0 Transceiver (Model 14-REC20) to work correctly. Ridge Remote Visor Clip WHAT’S WHAT The Ridge Remote has two programmable buttons and a status LED.
- Page 2 I N S T R U C T I O N S RIDGE REMOTE (433 MHZ) Model 14-R433 3. When LED flashes twice, continue holding button you want to program and release other button. 4. When LED flashes again, release button. Button is now programmed.
Need help?
Do you have a question about the 14-R433 and is the answer not in the manual?
Questions and answers